Search results

Looks good but also very over priced. I got all my inlets plus all mounts, subframe, wishbones, arb and subframe supports for less than that sandblasted and powder coated.

To be honest mate you've done it the right way lol. I've had mine nearly 9 months and still not touched the track or road! In reality I should of just got it road worthy then upgraded as I needed, all this money later the lesson is learned 😂. I'll give you a shout in the near future...

Looking good mate, will need to have a look at some point!

Do you also carry a digital camera around to take photos so you don't have to use your phone?

That open interiors mod looks fantastic! Strange why rockstar don't allow them to be entered on free roam some of the detail in them is great.

Cracking car for someone looking to get a ready built track toy!

Done all mine yellow then also the subframe etc the same:

That looks rediculasly cool!

Good luck this took me ages to get it over the rack, there must be a easier way as I nearly gave up lol.

Yeah 12.9 the bolts are. I think maybe in the long run I'll switch to eye bolts to keep everything in line, I'd say these are more than safe enough just now though.

And the other side is attached here:

No because it's bolted on top of the subframe, won't effect the level.

1 per seat for the inside lap mount, I mounted the other side via eye bolt in pre existing hole. Yeah on top of the subframe. I'm sure eyebolts would be better but for normal track use this does the job without drilling any holes.

I used 1 of these per seat for the inside mounting point. They bolt to the subframe bolts and bend up allowing the harness to clip on. http://www.msar.co.uk/motorsports/Race-Harnesses/Harness-Accessories/Harness-Hardware/Schroth-B23A-Bracket_88.html

That's a bloody bargain, wish I'd just bought one done and saved £k's haha

I think I got the fronts from Jcc rally mate and the tears were from pms. The studs are also pms, the longest type iirc. I did have Dan@MAD spacers for the front but I don't like the idea of bolting a wheel to a spacer and then spacer to hub hence going for the long studs.

The positive cable runs in to the junction box to feed the loom etc. You then just connect the negative of the new battery to the body work somewhere suitable.

I put mine hear mate. Ive got the battery through a mega fuse then to a kill switch which then runs in to a junction box in the engine bay. The kill switch is also wired to the ignition.

I had the same issue mate was scratching my head for a bit, as above just used a bar and screw driver for the hole.

Cheers guys, yeah the thread title might need amended soon 😂

Haha and the rest :cry:

Yeah it sits fine mate, i was the same when i first got them but really happy with the height. Heres a better picture of the full height, obviously 15's too.

Yeah mate nothing in the back.

2118's on Bilsteins with 15mm front and 10mm rear.

6 point safety devices cage arrived last week from @markfishy. Nice bit of kit, comes with everything needed. Hopefully get the plates welded in this weekend, put it in to see what it looks like really liking it :smiley:

Bump! Tried out the shaders mod and a few new textures the other night on a modern build. Impressive for minecraft, my Macbook Air's i5 was reaching 101 degrees lol

Done a trial fit of the new cage:

Just came home to mine there going to test fit, is it hard to get in lol?

Got the PAS pump mounted and connected up the hoses, just need to get someone to get power to it for me. Took a quick picture with the inlet off, would look so good with ITB's! And one in the sun today