Search results

It should look more like this on the bottom: http://rstuning.co.uk/197graph.jpg

OOps!!!! Look at the intake temp That graph is worthless Ambient and Intake need to be within 10 degrees or the result can be seriously affected

Thats a nasty dip in torque right where it gets a little richer. Don't forget the dyno dynamics are also classed as "ego buster" so maybe not too much to worry about. If the knock sensor is faulty that does need attention as it won't be adjusting advance if there is any det. Paul

We can map your stock ecu to take the cams. Paul

That sounds like an over optimistic dyno!

Looks like the heat shield that covers the starter

Without clicking the link i see the 20hp and think 2pence resistor to trick the IAT sensor. Don't touch!

Yes but that is reprogging adaptives basically. Unplugging the battery does not do this so probably not worth doing. Paul

U can get a freesat card from sky to get the free channels I might have a spare if u want it Paul

IMO unless you are going to do the Cambelt too don't do the AUX belt, you might as well do them at the same time. We are £429 inc VAT for the Timing belt kit and AUX belt, fitted. Paul

Don't drive it mate. It could be a faulty tensioner or even just an over tensioned AUX belt but not worth the risk

When did you send it mate? not sure i saw the graph only the figures. Cheers Paul

Due to arrive on the 10th of June

All is good then :D Just a quick update. The dyno should be here in 5 weeks depending on how long the boat and customs takes. If you wanted to arrange a RR day we can certainly arrange a special opening rate for CS ;) Cheers Paul

Remap from us will give you about 12lbft

Yes sort of. We are seperate to the garage side(ex renault service point) but at the same location. Cheers Paul

:D

Hmmm, 1.8 bar boost. i have a plan lol P.S. It's still a nova lol (runs and hides)

Your caps lock is stuck mate

Yes. The standard ECU will be fine. Paul

Ask them to advance the timing 2 more degrees and see what they say! Most people who sell chips on ebay don't have a clue what's inside.

The clearence on this dyno is fairly good actually but the lowest of the low may still struggle.

No problem :D

No, having it above the ground with ramps. Also makes it easier to strap the cars down :)

Ouch, there is a bolt holding the clamp on which pushes the injector down. Sounds like they stripped this. It will need a heli coil. Paul

They have confirmed the dyno is ready tomorrow so maybe it will be here in 5 weeks! :D

Glad your happy fella. Hows the car going? Cheers Paul

LOOOOOOOOL PMSL How many remaps u had now :D lol

I can't comment on the Group N setup as i don't use them. I can tell you the AFR on our maps is better than that! Paul

Who said it's 15k :rasp: