Search results

Found this "Found the solution they do slide side to side and not much else, you have to get a flat headed screwdriver and slide it along the rubber, there are metal metal pop studs 4 in total, the first one is approx 2 1/2", then the other 3 are 8" apart, they will pop out of the plastic...

Looks great does that!

You notice the change in viscosity the most

On the FIA a washer is required, I'd be surprised if it wasnt the case with the ABE. I'd double check that.

I think @leeds_182 tried organising it but noone wanted to play with him

Yes

Probably still works down int' pit

Paul is the dad of the Yorkshire group

Your words hurt

I've had 5 people in my car and only scrub on the rear over bumps because its bottoming out. I'm not lying I promise

You can only go so far over before the sidemounts touch the edge of the subframe anyway, but I believe one of the holes lines up, another needs ovalling slightly then drill 2 more. May need to do all 4 depending on position for the driver

Hi mate, I'm going to be fitting the FIA pole positions, FIA sidemounts, double lockers and Jon foz xlow frames in my car too. Have you assembled your seats yet? The new seat belt guides are utter toss in the manner theyve been finished which mean the washers tend to touch the leather. They...

Not heard of it myself, looks half decent!

You can change the gear before the limiter mate

No, I dont have a photo i'm afraid, it wasn't a lot. I run arch liners both sides, It has worn ever so slightly where tyres have scrubbed in big potholes etc but i've run them for 2 years.

I run ET43 2118s and 195/50/15 tyres with 20mm front spacers and 10mm rear axle spacers. I did have to hammer the front bracket for the bumper ever so slightly, but the bumper still fits perfectly as OEM. Zero scrubbing now and i'm lower than @YorkshireKyle

Use proplates

I painted mine, scrubbed them in the bath with lots of degreaser and they came out well. Just need to sort the rest of the bay!

8200208335

Cabasse auditorium with cars that have sat nav. I think, will double check.

I'm wise beyond my years me :LOL:

Looking forward to seeing the build on this.

You can do a good job spraying them too but if you want oem may aswell vapour blast.

20mm front and 10mm recaros perfect with these.

Yeah, me. They were done on a fairly cheap 3d printer and never identical to the proper ones. I've already mentioned for someone to send me a blank, I'll cad it out and then upload the file for free use.

Ffs

Are the washer blanks for sale mate?

De-valuing the neighbours houses one rusty Volvo at a time 😂😂👀

Imho, buy him a car that is considerably less than 2.5k and put the rest of the money either into the insurance or into an savings account. Hes 17, hes going to he pulling up the handbrake down at McDonalds and reversing into walls. Once hes matured and actually learnt to drive, use that money...