Search results

Sell that rear bumper to @Romanian Tyre Fitter so he can finally sell his 182.

Bought those grommets @Touring_Rob failed to link to 👀 (for ref. https://www.amazon.co.uk/dp/B07H9BZ7CG/?tag=cliospnet01-21) This one is the best size as you need to cut a wedge out of it to fit it. Unless you buy them before and fit but I wasnt that prepared 😂 Protects the line perfectly...

I need the car tomorrow so didn't want to push my luck!

Sweeet. I did measure them as needing a 7.5mm ID and 14.5mm OD grommet but if I just get that kit might be as easy. Cant say I see them wearing through anyway really.

Today I went out to be greeted with a small puddle of brake fluid coming out of the nearside rear brake line. Luckily it was tiny and hadnt completely drained the fluid and as I'm on annual leave this week meant i could sort it out! Had a set of @BRT Motorsport rear axle lines in my parts box...

No. You need the donut ring.

I'm actually back home now too 🥵

I'll summer you in a bowl.

HOOOLLY SHIIIETT PORL U DID IT

Its Carl.

Was nice this before the meg engine went in it

I literally just sold a set of 60mm hubs 😂

Fixed that for you.

Hows it look from the other side of the hub? They stick out a bit dont they? @Touring_Rob did his recently

Surely if the front hub nut has been torqued up to spec it should be sat in the correct position? I'm still going with the hub being bent

It's easy to check if bent but some shops often use the carrier bolts to support the hub during pressing.

More than likely theyve bent the hub. They need bracing properly as this is insanely common when garages just throw bearings in.

https://www.brtmotorsport.co.uk/collections/braided-brake-hose-kits/products/brembo-caliper-link-hoses

Had some black stickers in my kit so just shoved that on and I'm pretty happy with the result! Red rubber grease on the piston seal and pistons then dust seals pressed into place. Fitted my braided link pipe from @BRT Motorsport which looks ace. Now to do the other one 😂

Its gonna be stainless then 😂🥵

Will it include multiplayer? Or is it literally only multiplayer on 1 game mode?

Coatings on the mating faces for either the wheel to hub or nut/bolt angle.

Dont need to look behind you, only ahead.

Itll be the ones on the far right (black cables going to the pin). The corrosion will be obvious

The foglight will be the earth pins on the rear light connectors

I'll get some special brumbo stickers I'm happy with the colour, need to resist touching them too early now! Stickers are gonna go over the top of the lacquer as read issues with them causing air under the lacquer and peeling them at temp. How true that is I dont know... Silver or black are...

Thanks mate, appreciate the kind words! Started painting my brembos after all the prep. Took my time masking, using orings in the seal gaps before finishing with tape. Ear plugs were also used to block all the holes up! Only 1 done so far as I ran out of orings. Pretty happy with the finish...

They barely manage to fit a wiper