Search results

PBS are pretty dusty from my experience

My fan came on during bleeding once up to temperature, but I didnt run the heaters iirc I bled mine quite late too I think

Turn the heaters off/go for a short drive and take some coolant with you. I just kept the cap off and ran the car for 20 mins whilst squeezing the top hose. Undid the bleed screw again and coolant pissed straight out with no air.

You definitely need to lower the subframe. Basically, undo pinch bolt on rack, remove nearside subframe bolts, fully loosen drivers side bolts. Remove hubs both sides, disconnect ARB, remove shocks as it's easy to. The whole lot then wiggles out the passenger side

Just drop it out the bottom. Much less faff

You monster.

Is the stalk original or been replaced before?

Probably temp sensor, they're cheap enough to swap out iirc

Likely your coolant temp sensor, how is your temp needle acting?

Been proper cracking on with this! Going back to this post, the first photo is of your alarm system. If you cut open the bundle youll find a connector inside where it joins to the LED. I've unplugged mine and trimmed it down, laziness from the alarm fitters! The connector under glovebox...

Did you try cleaning the earths on the rear lights? I cant say I've seen it as bad as you're suggesting before!

Started on removing the casting marks from my brembos this evening. Managed to get one pretty much there, just need to do a tiny bit more prep on the side. It takes alot longer than first anticipated with a dremel as I dont want to go too far and damage the integrity of the caliper. Much...

Having used the passenger door all week to get in and out of the car I got round to fixing this for the 2nd (and hopefully last) time. Removed the door card again and pulled out the solenoid. Frustratingly the tiny clip holding the metal arm to the outside door handle just snapped off. Managed...

Imagine the fumes off that fibreglass if the clio went up

Here's the absolute monstrosity.

The join will just be condensation forming, nothing to worry about really as they seal themselves when warm.

You've replied to yourself 3 times now. R u ok 😂

Wow that is stunning! I'm surprised just how much it suits LY. I'll send you some photos of the centrecap via pm

It's a challenge because of the shape to get a decent print. I want to try PLA as I can get finer detail and check fitment before moving to the proper material. Hoping to have some out by the end of the month

The f1s look fantastic on it! I can make you some centres for the 2118s if needed 👍

Mine looks like the first photo... mud protects all.

Did that pothole come out of nowhere? It's huuuugeeee

Just hold it on the limiter for 10 minutes in the morning. Soon get hot 👍🥵

Watched mine on the way to work this morning. 6 mile journey same as @Pistachio with my blowers on the windscreen all the way at 16c (not 24c because I'm not a heathen). Temperature sat just below middle most of the way but then in the last mile or so it got upto halfway. Does fluctuate...

Still intermittent! Ordered a new (used) solenoid for a tenner off Ebay. In the meantime I'm getting in and out the car via the passenger door 😂

This doesnt really help as theres multiple.

My actuator is playing up again... anyone have the part number?

Doesnt even look that bad? Dont know what mine goes to now! What's standard? Just over half?

You need to shave your legs a bit mate

Looks great mate. ClioMaster.