Search results

Are you applying lacquer too after the paint drops? I have a fair few stone chips itd be nice to fill. Seen people just use cocktail sticks before now

Henk will probably say it's too old and pull your pants down

Can you borrow a snap-on diagnostic from anyone? They're pretty good at showing your airbag fault location. Abs wise, just spin the wheels and check the sensor resistance first

Common on hubs. Pinch bolt needs to be fully tight otherwise the balljoint can move up and down about 5mm

Coat it in ACF and it'll be fine.

Not really mate. I bought one from James JMRS Mitchell and it's been absolutely grand. Was like £15 too

Buy a good used one

Just measure the one that didnt snap

@bloke is close enough and highly recommended

Dont want you showing everyone up

Its PH-quick though

Diesel lupo

Hes active on here

They're like £17, seems daft for one just with proper clips!

Probably get ECP to price match.

Bargain! I might buy a new one from ebay at some point but i'll probably forget all about the bodge/fix and leave it!

I've a strange creaking/knocking noise so I decided to buy some balljoints as they're simple to change. Pair of lemforder from ECP for £36, were done 3 years ago so even if it doesn't cure the knock least they're refreshed. Then got round to cleaning inside as it was absolutely hanging and...

Looks like shes caught a wall, no? Doubt it's another car to only touch in those places

Did you fill it up until it came out of the fill hole? Could just be where its run down the block.

Plastic cover causes condensation. Give it a long run and it'll be fine