Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Duct tape some small hose to the nozzle of the hoover, you should get into the cylinder with it and get any swarf out
Thank me later, hose on a hoover has served me well with loads of different s**t
When I get my cage in I'll try and book onto Oulton or Cadwell. Would have been booked onto Blyton twice and Cadwell but covid scuppered those and I had a nice fat refund to spunk on more parts 😂
I'd have booked onto something again for when stuff re-opened but the gearbox had other ideas and...
Some, EML was because of the decat which has gone off, ABS has gone of since driving it but airbag, TC and serv were on before because my angle sensor is a dick and my steering wheel airbag is a shithouse😂😂 Ive got an RS Tuner with all modules but need CLIP to reset the angle value
Gave it a...
Not compared to my Megane. I'd sooner do 10 Clio gearboxes compared to that heavy motherfucker! 😂
In short, subframe out, gearbox out, check clutch, gearbox in, subframe back on. Not the worlds hardest job but can be a bit of a pain if you don't have much knowledge
Part 3
Now it wouldnt be a Clio without something going wrong!
Drove it for about 40 miles and started hearing a slight clunking from the rear, pulled over and instantly knew what it was. Rear shocker had worked its way loose. Really really lucky it didn't snap the bolt off in the beam...
Part 2
Whilst under the car I noticed this
No not the cable tied brake line @Louis! Pretty sure that spring aint meant to look like that🤔
Swapped all my springs for some Grams ones i had in the garage
Exhaust all back up and bokted together, was a tight fit but no leaks after I blebbed...
Part 1
Stripped the gearbox, manifold and cat off the other day. On the passenger side the selector seal had coated that side and my CV on the other side had just decided to exit all the grease onto the block and everything else in sight. After a few hours I had the subframe off, box out and...
Yeah try a full residual power drain by leaving everything unplugged for 1 min with the cmos battery out too
Rule out any hardware issues before getting your parts cannon out😂