Search results

You using a hole saw for these? Lovely clean holes

In tight places like this? Surely you're at a huge risk of damaging the rear quarter?

The bristle blaster. We have one at work for prepping pipes before deploying probes, savage things! I would not be using them here. They leave marks that look just like pitting! Small flap disc or drill wire brush will be perfect for removing the rust here

Youre meant to use the scenic one, just one hole needs elongating

And built.

My shifter is coming along now. Going to re-assemble with red rubber grease on everything then get it fitted. Hopefully it's stiffened up slightly too but time will tell. I fully mig welded the bottom extension id previously tigged, ground it back and painted.

Correct. They do stick out but you can get the centre caps on, just.

68mm rears and 82mm fronts

On my Clio I run studs and with standard 182 wheels I was able to just fit the covers on. I also use the same studs to run 20mm spacers and ET43 2118S. Can't remember the length, it's on my thread I think

They're ptfe, not metal (Or shouldn't be). I presume yours were replaced before you got them @alistairolsen

Gay

Cheers all, quite happy with them considering they were only on my phone. Think i went overboard on the sharpen button though. ET43 2118S with 10mm rear stub spacers and 20mm front hubcentric spacers.

Just without any scrapes would have done!

Hammerite isn't as good as it once was. I'd get some zinc phosphate on it first as a preventative then hammerite if you want to go that way. Just make sure they won't react. Hammerite reacts with everything

Or buy one, they're super cheap

That was me mate.

Thug lyf.

Time to make another thread!

Jesus, that's bad! Usually these places gun them up so you'll never get them out, not the other way round.

My phones dead, but i'll whatsapp you later mate.

Do you have any rolling shots or video of this? Bet it looks so cool hooning about! Some lowered vans just look s**t and half arsed but yours is ace and done perfectly.

Wheel ends today!

Or just unplug the siren.

Push the interior sensors down into the pillars and see if it makes a difference. Check the wiring on them too as they're often dodgy. Have you tried leaving the battery disconnected for an hour or so? As a temp fix, get in the car, lock it on the button inside then get out the passenger...

Yeah it was massive, got dashcam footage of it too!

Took a few photos I'm quite happy with! Did a quick edit with them on Photoshop, trying to get better but these were just taken on my phone rather than a proper camera! Any Photoshop tips welcomed 29784722498_65dcf9cb49_o by Louis Walker, on Flickr Editted with vignette by Louis Walker, on...

Are you sure the calipers are working? Moving the arm pushes the piston out?

I'll give it a go! Will i touch it in with primer, paint, lacquer then wetsand? Or just the base. I have touchup pens with all 3.

Took a trip to the Lake District and used it as an opportunity to take some photos as the scenery was ace. Also had a play at editing them more on photoshop, still getting the hang of it and what order to do things in! Hope to eventually get a proper DSLR as these were just taken on my phone. (I...

I'm pretty sure some cars came with the switch pointing the other way so it may have been replaced at one point as the 3 dots are meant to be closest to the dash