Search results

Ring in a sickie bud

Will be on for a mega session t'neet like

Let's face it, WZ runs like a heap of hot shite anyway so it won't matter what graphics card you have🤣

Yes RIP You for buying a 3090Ti🤣🤣🤣🤣🤣🤣

You'll need to remove it and give it a proper clean out with a hot wash, they're notorious for blocking and then only partially unblocking enough to turn the light off Be very careful about forced static regens as plenty of Renault and Nissans have set on fire because of them

Yeah I'm gonna buy a new one and then repair the others, I'll make one good one from the 2 and then see what else I need Gonna be picking your brains in the distant future "Rob how do you resistance test an Alternator" "Rob how do you set up a rig to bench test an Alternator" "Rob why does...

You're quite the sexy man Managed to find a Valeo unit for £163 on Autodoc

I believe that's the one The purple one

This is a 75A cup alternator mate The cheapest I can see for a 110A is here on Autodoc https://m.autodoc.de/valeo/1081040 ive got a voucher that you can use so takes it down to £187 iirc

Yeah the brushes and bearings are a piece of piss to get hold of mate. There is another Valeo model very very similar but uses a single wire exciter on a post instead of a 2 pin connector

One of them deffo needs a rectifier which are about £75 on their own if you can find one😭 I'm gonna get the one currently on the car rebuilt. Spoke to Tom earlier and he said he has his rebuilt and the last one was £120 for refurb🥶

Came out this morning, car threw out the STOP and battery light FFS Went out when the sun came up to have a look and test. Not getting any charge from the alternator🙄 Tested at the battery and directly off the back of the alternator Set about removing it, immediately snapped the terminal off...

Yeah that's a proper cheap s**t and nasty shaft

I wish I hadn't have seen that

Was it these bearings you used Frayz? Think I'm gonna refresh the ones on mine

Never even noticed the lack of washer jet holes, looks so much cleaner

Can't believe nobody has tagged @Louis yet🤣

Yeah SNRT make the bearings for Renault Never had any issues with them

Everyone report him

Nah get the fuel one

Innit, he's dogshit👀👁️🤫

Cmon @Cub. Can't believe you've been hacking all this time mate

"Ur a fat baldy c**t" 😂

Bar needs to stay in, they're welded either side Are you having it painted or powdercoated?

Andy Hutchinson is up your neck of the woods Jon

Was probably mates rates £40 to anyone else 'because I've got loads of development time in this'

So priced higher than the eBay ones then🤣