Search results

my vote is for dann too, just don't put him in charge of wheel tightening.

Yep, Hi everybody I have issues, My name is Dave and I can't stop buying cheap french money pits.

s**t, hide , please don't sue for copyright!

I'll come in a clio for once and bring the RB cup

You've got looking at trailers again now, I can't afford/fit any more shite on my drive at the minute, smashing trailer George I wish I had space.

I bought a set of 182 cup shocks from renault parts direct the other week for £140 they're now £190

I'm easy, next sunday at 11am?

@dann2707 are you bringing the tripod?

anyone fancy a mini meet at The squires again one sunday for a cuppa and a natter

That didn't happen at 40mph, did it!

lower ball joint shat itself,

Why don't you set it for 4am and do the pads and wheel swap in the morning, you don't want to be getting the car ready for tomorrow too early do you! :smile:

1.4 degrees toe in will be terrible As Northloopcup said 14 minutes of toe out is your target

could it have the longer 182 cup tie rods fitted?

try a coolant temp sensor

OP means the length of the aux belt on a 172 cup set up with PAS pump removed it'll be something like a 6pk850 but don't hold me to that

Sport lines are a bit cheaper from Germany http://www.ebay.co.uk/ulk/itm/321927308074

A copy of pure motorsport kit by the look http://www.ebay.co.uk/itm/Clio-172-182-aircon-and-pas-delete-kit-/151939365261?hash=item23604ab98d:g:T~0AAOSwa-dWi3K1

Dodgy throttle body or drawing air in the inlet gasket would be my first guess

low 6's in the hillclimb car 4's with a ktec remap minimum!

I leave moisture traps in my cars that don't get much use, http://www.ebay.co.uk/itm/201472903643?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT I also start them up once a fortnight let them get up to temp and drive them around the block while left foot braking and easing the...

top work, the maxogen looks well like that

The port work is factory, Regards knocking, is the dephaser shagged!

Undo the bleed screw on the stat housing, if that's ok change stat,

I had a sum up at work a few years back how much an Iveco daily van would cost from the parts bin as the prices were ridiculous, a £22k van worked out at nearly £110k, plus fitting

That was over near Malton Dan, no, only going really steady but BMW in their wisdom have put the intake in the front grill,

Dropped a right bollok, after 2 hours of waiting for BMW assist I got bored so with nothing more than BMWs supplied flat blade screwdriver and a top notch swearing phrasebook I got it running after removing the air filter, air box & intercooler pipework thank fcuk for that! all seems fine but...

Yeah mine is only noticeable in first gear when turning sharply and even then not any where like as bad as the older grippers I've heard

I'll give you that, it is pretty near perfection yours, I've got the 8oz tapping hammer if you prefer, i'm good with that