Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Hello guys! Im looking for picture parts I need
2x Lifter + Rocker
Anyone have it for sale or know where I can get it?
I try to get them from Sodemo but no answer. Impossible contact.
Cheers
Ivo
All the 433, 431 and 434 make good power, I would chose the cam regarding in on what type and gear ratio or engine preparation.
434 make a very linear/flat torque curve, not the big torque at 5800rpm that 433 makes.
The engine made 245hp at 7800rpm (Engine) and 245Nm, similar curves that...
I build and engine with 434 from cat recently.
You will get a very tigth intake Valve to Piston distance but OK at 4.30mm TDC timing in case you are using Wossner std rod size, If you use the long rod version Piston KIT (Super car) you will get some extra 1mm aprox.
Regards
About the timing on 197s l, its a matter of piston valve distance on intake, i didnt remember the axact advance on intake, I measured the and 8° After TDC Valve to Piston distance and I use that as Limit.
On exhaust You can r****d a little.
The reference that I have in my Dyno tests, are from head face to the end of trumpet.
I run 3 trumpet sizes on 45mm Jenvey with both, Cat 421 and Clio 197
25cm: best option for track power up to 7600 very stable AFR. 229Nm 213hp at 7200
28cm: best option rally, more 5nm at mid range up to...
Hello guys, the shock absorbers (KYB) from my Clio 197 they need to be replaced, any suggestion? I woul like to keep std system (not coil over). The Clio 197 cup absorbers are diferent than non cup?
Thanks
Hello guys, first of all Happy New Year!
I’m Re-building a Clio 197 R3 (230hp) engine spec.
Anyone knows the big bearings and main bearings clearance ?
Anyone have R3 / Maxi engine assembly manual?
Thanks
Hello guys, anyone knows if the 5th gear of JB3 is interchangeable with JC5?
I would like something shorter than 0.79. ideally between 0.82 and 0.85.
Thanks
Thanks for your feedback, I will assembly with a borrowed 45mm jenvey inlet to start. After I will decide which one to go. I will post the dyno graph ASAP :)
Cheers