Search results

Ok cheers KDF, ill do that over the weekend and let you know the outcome.

JAY172 Do you mean to test the abs unit itself or the sensor, i am presuming you mean the sensor, but just checking with you. Thank you so much for your help.

Cheers everyone. JAY 172, how do you do a resistance check on the sensors, if you dont mind explaining to me? I have had the car checked in a garage on the abs machine, but this was before the light came on, and the car was also standing still whilst they checked it. The machine came up with...

Thanks a lot for all your suggestions It must be the sensors as the light keeps coming on every so often. It does also do it at a very low speed . We have checked the teeth where the sensor picks up and they seem to be fine, we have cleaned them to get all the sh*t out aswell. Also the...

Can anyone help??? I own an L reg clio 2.0 litre 16v Everytime i put my foot on the break it makes a juddering noise and feel through the pedal, whether i break hard or soft. I have had it put on a machine to test it, but it states no fault found, so the abs is obviously working, but too much...

My car is 94 model, so not sure if it is the same as the Cup, but i also thought it could be some kind of sensor. I have had the ABS checked properly on a machine in my local Renault garage, and it picked up no fault, but the machine tested the car whilst it was standing still, so do you think...

My cars ABS seems to be kicking in all the time, but the strange thing is, is that it does it quite badly when i first start her up and drive, then after about ten minutes its not that noticeable. It vibrates through the brake pedal. Does anyone rate green stuff brake pads good, as these may...

You boys, what you on about. I am FEMALE, and a good driver at that!!! I drove my boyfriends Peugeot 205 turbo on the santa pod strip, and got 14.9 sec, beat my boyfriends time in his own car, he he. Well dont like to brag. Anyway, thanks for all the advice from everybody.(y)

Hi again, well the rear of mine has been dropped 2 splines, my boyfriend did it for me!!!! So its quite a drop. I did exactly what Ben said about cable ties, and it has worked so far, not sure how long it will work for. If it comes back then i will invest in the rubber mounts from Rally Design...

Ok well give it a go. Thanks for the help.:cool:

My Clio is a 1.8 shell with a 2.0 litre engine. So i am presuming it is the same as a williams. The pipe has a so called dent in it, but it is still so close to the pipe, the vibrations through the exhaust makes them touch each other. I live in Deal in Kent, if anyone knows where it is!!! I...

Sorry i gave out wrong info, it has been lowered by about 45 mm. Does anyone know if i could possibly dent the exhaust pipe with a hammer, just enough so it dosent touch the rear beam??? Also another idea of mine is to put heat wrap around the pipe, enough of it to stop that awful aluminium...

I have tried the search but i dont seem to be getting anywhere fast!!!!

I have just recently had my clio 2.0 16v lowered by 30mm:) front and rear, but the exhaust pipe is rubbing against the ream beam and making a dreadful clanging noise:confused:!!!! Could anyone pass on any sugestions as to stop the pipe from rubbing against the rear beam?????