75mm bore

[tom_dot_COM]

Looking at buying a set of wheels, they are 35 offset with 4x100 pcd, so should fit perfectly. However the bore is 75mm. Does anyone know where and if I can get required spacer/spigot rings for it. I want this to be safe I assume spacing it to 60.1 would be????
Anything else I need to know???
Cheers – tom b

 

[bmh.01]

What wheels are they? You'll be fine with spigots, think my old superturismos were about 75mm with the spigots out.

 

[drhowser]

the other way to do it is to use wheel studs and nuts, instead of bolts.

 

[tom_dot_COM]

these babies, what do you think, for a black ph1

http://cgi.ebay.co.uk/deep-dish-alloy-wheels-split-rim-look-15-rims-4x100_W0QQitemZ250174254990

 

[xcore]

surely u can fit them without spigots, they will just rest on the bolts more?

 

[tom_dot_COM]

will be tracking the car eventually, i want it to be secure and safe, so id rather not have a gap for the bolts to take up

 

[xcore]

guy on ebay sels spigots, you specify diametres