Hi guys,
Just looking for some advice, had a proper fail on Saturday at my brothers.
To cut a long story short, I closed the drivers door the seat belt was in line with the door sensor switch and the force of the door closing snapped the casing off the door switch so when I close the door it pushes the switch into the door panel and the door light is on the dash and the interior light is always on! The switch still works If i press it in by hand, but the casing around has snapped.
Just wondering if anyone has replaced this part (tips) as I thought about gluing it but no doubt a hard door close will knock it through again.
Cheers
Chris
Just looking for some advice, had a proper fail on Saturday at my brothers.
To cut a long story short, I closed the drivers door the seat belt was in line with the door sensor switch and the force of the door closing snapped the casing off the door switch so when I close the door it pushes the switch into the door panel and the door light is on the dash and the interior light is always on! The switch still works If i press it in by hand, but the casing around has snapped.
Just wondering if anyone has replaced this part (tips) as I thought about gluing it but no doubt a hard door close will knock it through again.
Cheers
Chris