Ph1 airbag and service light still on after resistors

[Korky]

The service light and airbag light are still on after installing 3.3k ohm resistors under the passenger seat, where the believed fault was, there is a resistor in the steering wheel as it is aftermarket.
The light wasn't on till someone moved the passenger seat and now won't go off, any one Any ideas?

Can I turn it off using the snap on diagnostic system or does it have to be clip?

 

[Reed17]

Try using the snap on diag, i know my foxwell computer does airbag and a snap on one is much much more advanced than that!

 

[Ex-User (19928)]

What about the driver's seat?

Unless it's been plugged into a CLIP you're never going to be sure where exactly the fault is, I don't know why everyone seems to think you can "fiddle with the wires" to fix it!

 

[Korky]

Cheers for the suggestions I'll try get on the snap on diagnosis

 

[davey247]

Did that work for you?? I need to take this on in the next month or so. Got an after-market wheel, but was there when I got it so I dont know if its the steering wheel or any of the seats :dapprove:

 

[MicKPM]

Bring it in to us - I'll sort it properly for you for £25 without any resistors.

Mick
Diamond Motors

 

[Korky]

The resistor method didn't work I'll get it plugged in when I get round to it.

Anywhere know of anywhere good in middlesbrough to go?