Quick help with under seat wiring

[jenic]

How does this clip undo?

Cant work it out and need to pretty soon before it goes dark!

 

[Rob]

Pull it?

You tart!

 

[jenic]

Pull it?

You tart!

Its tight lol, if it breaks i'll send you the bill :rasp:

Edit: Nope, its impossible to just pull it off, even when pushing down on the clip thingy. Must be something to do with the red thng?

 

[Jonny1*2]

Mike you don't need to unclip it as it's a pain. Just snip the wires off at the car end of the connector (if that makes sense), then attach the resistors to the wires. I'm guessing you'll need them bags turning off soon then

 

[C2kev]

Its tight lol, if it breaks i'll send you the bill :rasp:

even when pushing down on the clip thingy. Must be something to do with the red thng?

You need to lift the clip up, slide a flat screwdriver or knife under it. same as on a C2 by the look of it

 

[Craig.H]

i tired doing this and failed badly. just snap the clip that holds it in place! if you ever put it back just tape/tie wrap it together. its under the seat so noone will ever know!

 

[maclements]

isn't this for the airbag lol?

 

[Jonny1*2]

isn't this for the airbag lol?

side air bags yes, but he's removing his seats and the ones that are going in don't have them, hence he's messing with the wiring

 

[jenic]

I managed to find an old thread on here, was fiddly but they do come undone easily once you know how (stupid french design though lol)

Resistors are working fine so far, but yeh jonny, wouldn't mind them turning off properly along with the steering wheel airbag when I get a replacement Might aswell wait until then before doing any of them

 

[jenic]

.