thinking about matching my upper inlet myself.

[jaysjetski]

as above. has anyone got a thread lying around on what they did.

it cant be that hard. got high speed air drill and a dremel.

any pointers would be good.

thanks

 

[172Ben]

You need to match them to the lower inlet and the head.

 

[Bluebeard]

Jay, what are you planning on matching it too exactly??

 

[TimR26]

There's a thread in the guides section.

 

[jaysjetski]

i was planning on matching the upper to the gasket. then another weekend match the lower to the upper and head.

 

[Ben_Stevo172]

EDIT: OOPS!!!

 

[Ben_Stevo172]

I've been thinking of doing mine for a while too! I was told not to match them to the gaskets though! Havnt got a clue why!? Maybe someone can explain why?

 

[stan*]

Dont match the the gasket on the head 'cos the gasket is larger than the port.

 

[jaysjetski]

There's a thread in the guides section.

cant find it!!!!

 

[jaysjetski]

has anyone got the link to the guide for matching inlets?????

 

[Ben_Stevo172]

has anyone got the link to the guide for matching inlets?????

I have seen it in the past although now I cant find it!?

Im sure in the guide the chap matched the inlets to the gaskets though! This is what confuses me!!!! :S

 

[jaysjetski]

I have seen it in the past although now I cant find it!?

Im sure in the guide the chap matched the inlets to the gaskets though! This is what confuses me!!!! :S

i thought the upper inlet you match to the gaskets.

the lower to head is matched by making a template of the head and not using the gasket.