Whiteline Rear ARB

[t90_lle]

How hard is it to fit? I’ve searched for a guide but can’t seem to find one and the instructions seem a little vague specifically to a clio.
Any hints an tips would be appreciated.

 

[Coops Mk1]

piece of piss tbh, just unbolt lower rear shocker bolts and rest just bolts round the rear subframe, half hour job max

 

[Coops Mk1]

http://www.whiteline.com.au/instruction/Z319_BRR10.pdf

 

[imprezaworks]

Easy

 

[t90_lle]

piece of piss tbh, just unbolt lower rear shocker bolts and rest just bolts round the rear subframe, half hour job max

Will the shock/spring push down when trying to undo the bolt?

 

[imprezaworks]

you need to support the rear beam

 

[Coops Mk1]

as above, jack up on beam, pop an axle stand under each jacking point on rear chassis and drop car onto those

then just set the rear beam at whatever height to take the pressure off the bolts as you undo them

 

[Jekyll]

Exactly how Ben said. Its the same procedure as changing shocks really.

 

[t90_lle]

All fitted but how tight do people go with the nut on the L bracket holding the two bushes??

 

[imprezaworks]

Im sure there is a certain measurement, tbh i just did mine tight, not too tight if that makes sense.

 

[Danith]

Gave up with mine. Shock bolts were not for coming off

 

[Krarl]

Gave up with mine. Shock bolts were not for coming off

WD40 up the rear beam tubes onto the heads of the threads mate

 

[Danith]

Will do ta

 

[Krarl]

No probs mate, gimme a shout if need. Impact gun sorts the little dicks out no problem haha