Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Problem solved, it seems my rs tuner cable is hit and miss.
Odd because all the lights lit up on it and usually if it's a disconnect the program will tell you
Pulled the fuses they were OK, tested pin16 again and I've 12v off , 12v ign on and I've 14v with engine running.
So now I have power and still the RS tuner will not connect.
disconnected battery for 15min... still not working.
Ive no 12v at pin 16 either when ign off or on.
So I have a power issue, does the OBD have a relay or a fuse ?
Hi My OBD port is not working. Im using RS tuner and have isolated it to the car side unfortunatly.
Ive tried ign on, with the car running any combination and im getting no luck so I presume the power is gone to it. Is there a fuse or relay or something?
I connected it last week and it worked.
Hi I'm having little electrical issueswhich I'm hoping is common and all related.
My ESP and SERV lights are coming on while driving. The car still revs freely.
The backlights on the main cluster and the one in the middle are very dim, I've ruled out bulbs as they only dim (to the point of not...
Took the starter out there, seems the locating dowel is in the wrong place/hole. Would this cause the problem?
Starter moves free in my hand , moves out and back in freely. Bit of blackening on the earth wires insulation but the earth is good.
Yes engine is good drove it onto the drive before I took it out. Not seized either, I put it in gear and rocked the car forward.
I have a starter from the other engine that's also good as long as I've had it, so I can swap that just wondering what's causing the issue because I don't want to swap...
After changing the engine and clutch I went to turn her over there just to get oil pressure before I run it.
Problem is the starter is turning but the engine isn't cranking.
I've gave the solenoid a tap with a hammer and no luck. Doesn't seem to be the spade connector either as when I remove...
Changing the clutch at the moment and trying to figure what this means?
It fits onto the clutch alignment tool, but isn't solid between the clutch plate and flywheel?
Does it even need to be fitted?
Doing a engine swap at the minute. Have the damaged engine ready to come out. I have a donor 182 to remove a engine from. Im trying to avoid carefully disconnecting stuff as the takes all day.Where are the main disconnects so i can just pull the engine, loom and hoses all out together?
I...
I may be able so get my hands on a donor 182 if the price is right, engine swap sounds like the only way, I work shift so don't have the time to be messing around. I don't have a garage either so this is all driveway job. Not ideal but I've done it before on other cars in the open.