Search results

Renault quoted nearly £900 for a new clutch :dapprove:

Yeah sounds like you have the same problem as me, my clutch went last week - and it made a grinding noise, and then a sqealing noise!! Took it into the garage, and he phoned and said the release bearing was f***ed. To get my clutch done was £620.00, the release bearing was only £34 + vat

No warning light... Yes I may erase it and test again.... where is the mass airflow sensor??

I got this fault code on my car, does anyone know what I should be looking at? Thanks for looking. P0101....Mass or Volume Air Flow Circuit Range/Performance Problem

I don't know mate, I took mine off last night there are 3 bolts underneath and then just the screws in the wheel arch, and then pull the bumper off from the side be careful though as you can snap the plastic. Someone might have a guide on here though!

It is so much easier if you take the bumper off, it only takes 5 minutes. You will have to take it off if the ballast has gone anyway. :)

Ok thanks mate, Can I buy the adaptor??

I have just bought a Miltek De Cat Pipe for my 182, Will it fit straight on to the standard system or do I need reducer's or anything like that?? I got the pipe from Ebay but it did not come with anything!!

This happened when I first got my 182, I took it to Renault and they said someone had steam cleaned the engine and it made the plugs and leads go rusty, so had them changed and the light stayed off!! Not saying thats what is wrong with yours though :S

Oh right thanks mate :)

Is there a reason why my clock light dims when I turn on my Xenon's?? Does this happen to anyone else??

Its not a massive difference but you will notice it...:)

I had my williams chipped and it was great fun.... But as Mossy said don't bother with the Induction kit!

Is the ballast the metal part on the bottom of the headlight?? And are they £180 each side?? Would this cause the fuse to blow then?

Thanks for your help mate :)

Re: Haynes Manual When I turn them on the fuse blows straight away, I'm not sure if its a bad earth or a relay maybe!!

Re: Haynes Manual Yeah im pretty new to searching for things, and I have posted a couple of times without any luck!! I have a problem with my Xenons.

Re: Haynes Manual Oh right so you can't get any sort of Manual for it??

Does anyone know where I can get a Haynes manual for my 182??

Could anyone tell me why one fuse keeps blowing when I turn my Xenons on!!?? :(

If my Xenon bulbs have blown,will this cause one of the fuses to keep blowing when I try and turn them on?? Any help appriciated.

I recently had my 182 serviced and the guy said I am going to need a new drive shaft! Could anyone point me in the right direction as to buying one and the cost?!?!?! Cheers :)