Recent content by big_steve

I got incredibly lucky after hours of searching and managed to find one in Turkey and had to get it shipped over if I hadn’t managed to find one I was going to go down the route of removing it all and getting a brake bias bar setup

I’ll do some research. Thanks for the advice much appreciated

Yeah I’ll try contacting them tomorrow. If they can’t do the rebuild do you have any info on how I might move forward trying to get either a replacement or wether I can use a different one etc or know of anyone here who I could contact to get the info I need?

Thanks for the reply, do biggred offer a refurbishment service? As I thought they only sold the kits cheers

I need a new master cylinder part number Master cylinder : 7701207473 believe it’s made by Bosch and I know these are hard to get new, anyone know where I might find one new or can I use the biggred master cylinder rebuild kit BRM1480 and if so is this quite easy to do? Or is there and...

I need a new master cylinder part number Master cylinder : 7701207473 believe it’s made by Bosch and I know these are hard to get new, anyone know where I might find one new or can I use the biggred master cylinder rebuild kit BRM1480 and if so is this quite easy to do? Or is there and...

I’m desperately require a brake servo and master cylinder for my Clio 182 I know these are like gold dust, servo : 7701207751 Master cylinder : 7701207473 does anyone know where I can get new ones from or is there alternatives that fit as a direct replacement without any modifications to the...

Cheers I'll order the parts for an smi rack thanks

I need new track rods for my 54reg clio 182 cup but I can't tell which steering rack type it has because the sticker has fallen off. is there any other way to tell what type it is without the sticker?

I can't remember the exact size but if you have got the old clip use that as a guide and buy one that's slightly bigger so that you can fit it easier

Ok thanks, think I'm going to take it to ktec and get the bolts and camber set up properly

when hot, I monitor the tyre pressures throughout the day on trackdays

32psi on the front and 30psi on the rear

They are very easy to fit all u need is a few spanners a drill Allen keys and some spring compressors takes about 30mins to an hour to do and feels much better than standard

I had the same problem and found that the washers didn't work so I bought the ktec racing solid top mounts and this solved the problem straight away and also worth doing as the original mounts after time wear the hole in the turret into an oval shape so will only make the problem worse