ClioSport.net

Register a free account today to become a member!
Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Recent content by Leo182

  1. Leo182

    Seat tilt forward wire broke

    Anyone know a decent cable to replace it with. Seat won't tilt forward and I've replaced the cable with a bike gear/brake wire a few times over the last year but it always fails, so annoying. Ta.
  2. Leo182

    Canclip V203 help

    I know you've sorted everything now but that bit is what happened to us, I was pulling my hair out effing and jeffing trying to sort it. I sorted in the end by hooking up my laptop to a bigger monitor to see the bottom of the screen!
  3. Leo182

    P0130 and P0135

    I had a P0130 fault code and went and bought a new Bosch Lambda but before I went to fit it I drove it for an hour on the motorway to ironically pick up a 22mm sensor socket only to them find the EML light went off on its own! Mpg seems a tad lower though, was getting 30mpg and it's dropped to...
  4. Leo182

    Spongy brake pedal after front pad change

    Cheers lads, will see how I go tomorrow with it, I'll be sure to give it a thrashing ;) Is the sensor or wiring anywhere near the brake fluid bottle? I only ask because when I spilt some it went down near the manifold and it was smoking a bit down there! I did obviously turn the engine off...
  5. Leo182

    Spongy brake pedal after front pad change

    Here we go, cleared it and it's gone off however not sure if it will stay off. Didn't think so, I did spill some brake fluid from the Reservoir and ran the engine before I noticed, maybe fried something??
  6. Leo182

    Spongy brake pedal after front pad change

    Pedal is firm now so happy But engine management light is on now wheres it wasn't before, brake fluid is above the max slightly could that cause it? One issue after another!
  7. Leo182

    Spongy brake pedal after front pad change

    Eezibleed, will try again with it along with a few pumps of the pedal for good measure I've seen it mentioned some people have done it with the engine running and that's sorted it after forever struggling. Will give them a go before the local garage visit with tail between the legs.
  8. Leo182

    Spongy brake pedal after front pad change

    Results are in... and it's a big fat fail (n) Bled it and surprisingly no air bubble out came out, gutted. I shall rebleed them all again starting at the rear, i tried the Renault recommended order and it's hasn't done the job. Pedal feels great when the engines off lol!
  9. Leo182

    Spongy brake pedal after front pad change

    Hoping so mate, will post back tomorrow to see if the chase is on.
  10. Leo182

    Spongy brake pedal after front pad change

    Update. All fitted and was very easy tbh, however the pedal travel is still the same :( Now I've bled 3 wheels however i couldn't do the OSF due to an issue with the locking wheel nut which I've just managed to undo. Question is, could this one side that I've not bled be the cause for the...
  11. Leo182

    Locking wheel nut slipping

    Any ideas on how to get it off? No problem with 3 of them but the drivers side front is just slipping off.
  12. Leo182

    Spongy brake pedal after front pad change

    Arrived today so very happy with the service too, looks like this Josh lad is a good fella (y) All i need are fitting instructions now as they weren't in the box, mark them down on that 😆
  13. Leo182

    Spongy brake pedal after front pad change

    I did have second thoughts ordering when I did a search on here! It's been posted so good start I suppose!!
  14. Leo182

    Spongy brake pedal after front pad change

    Paul was one! No doubt he'll probably get back to us but i couldn't hang around unfortunately as i need the car back running asap.
Top