Recent content by rik220

Have you ever heard the car run right? It may be timing related, which would also throw compression off. New dephaser pulleys MUST be checked and confirmed that they are locked prior to fitting. I replaced the dephaser in my 265 meg yesterday and it was not locked. You need to put a nut and...

Not sure that the immobiliser will be stand alone? Surely it’s incorporated into the UCH? Is there an aftermarket alarm/immobiliser?

As of this week, I now own number 15. It’s currently on 99065 miles. Surprisingly excellent condition.

I may just do the same actually. Order a trophy centre cap and get them to match it...

Hi all, I have a set of 172 cup turinis which I fancy getting refurbed for getting my RB182 out of the garage and MOT'd soon. Can't quite make up my mind on colour. Thinking either a fairly light coloured grey or silver? Also, my car is totally standard and so is at standard cup suspension...

My issue was valve clearances set too tight. I’d set them for the non grooved cam. I found the correct clearances for the grooved cam d4f and it’s been running fine since. Sent from my iPhone using Tapatalk

Hi all, I'm need to do the timing belt on my 2.5 dci master. I have the locking tools etc but would like a renault workshop manual for this. Would be must appreciated if any of you could share a workshop manual for anything with a 2.2/2.5dci engine or laguna etc. Thanks, Rick

Hi all, My 2009 1.2 16v Clio was running fine. I then checked and adjusted the valve clearances to 0.10mm inlet and 0.20 exhaust. First start up after this it was misfiring at idle. No fault codes. Engine will stall if held on slight throttle. Revs initially lift, dip and then stalls. Engine...

Hi all, My brothers 2009 1.2 16v Clio had been sat for 18 months. Started up as if it was running the day before. Drove it up home and check injection appeared. Clip is showing it as a throttle body fault. It’s intermittent so it sometimes isn’t present when the engine is started. Live data...

I had to do that to enter the serial number. Generally isnt an issue when using clip except when trying to change configurations.

Sorted. I copied the probes files from my netbook and its working fine, When I plug it into an older car like the clio, and it wants to start an old version of clip for diagnosis, it fails sighting a .dll fault.

I was using Clip on this laptop through VMware running W10 32bit. It was too slow so I just done a clean install of 32bit on it as I got a new laptop. The netbook is windows 10 32 bit and it works no issue. Problem is the screen is so small there’s parts of Clip I can’t see. Sent from my...

Hi all, I installed V203 on my W10 32 bit laptop. I have the china clone RLT2002 probe. Works fine and have been using on my old x86 Dell netbook for a while on V193. Drivers seem to be installed ok but I cannot find the sensor when I open clip. I changed the probes files in config for the my...

For me I changed the cruise control buttons on the steering wheel and it fixed my issue. I also had intermittent cruise control not turning on at all before I changed these. Speed limiter was turning on I think. My brake switch was fine. Sent from my iPhone using Tapatalk

Is it not push on metal clips that go onto these? Sent from my iPhone using Tapatalk