Recent content by Tomo3292

Thanks mate I'll look into that

Any wiring diagrams out there for the clio 172 with regards to Omex 600 ecu. I am abounto purchase a set of bodies/ ecu and looking at what wiring requirements are needed. TIA

@Nathan Evans what's happened to the giant killing blue blur. I've seen it for sale, any movement on it this far? Be great to see you in the next spec up, especially shorter small single venues. Also When you looking at 1st event? Anything in the pipeline yet?

Sorry shouldn't clarified I did have standard cup shocks and eibach springs. Tyre wise I have 15 inch ozf1 with r888, standard but brand new front calipers with drilled and grooved discs.

After some advice on what is best for some track use. At present I have PMS top mounts and strut brace along with full progoex black series bushes but unsure as to what suspension setup would be best. And decent coilovers or springs people have used? Budget isn't massive just after some...

I've installed a full new battery circuit in my track car mate. Battery relocated to the rear, runs through a 175amp mega fuse, then into FIA electrical cut off. From there onto longacre bulkhead connector. I'm in the process of modifying my loom both parts, removed the old battery alternator...

Gents I am after some advice, Timing up the engine and the inlet cam seems to want to look on the horseshoe all the time. Last time I did it I recall I didn't seem to have this much an issue. I've tried putting a feeler gauge in there but the inlet cam still springs back on the horseshoe, and...

The way you drive I can see some giant killing results in this little pocket rocket

I don't suppose you could remember what guage / size wire you used for the alternator/starter circuit. I have cut mine out as it's in a bad way and looking at replacing something similar to your idea. Struggling to find the size of I am honest.

I'm going to make a new cable going from the battery to alternator, starter motor. I did not take the size of each before rushing to work this morning. Anyone able to confirm the size for me please?

In awe at the workmanship throughout this build. Lockdown has had it perks, mainly reading through your thread. Firstly massive kudos on the build, the racing season, and the new business adventure your embarking on. Would I be able to pick your brains on a few of the electrical issues on...

good progress mate, this is something I am looking to do. I don't suppose you have the diagrams ? would be very much appreciated and save me from purchasing a 3rd loom lol

if your a member theres a good guide, in the guides part of the forum. Really in depth and should cover everything you need

I assume you mean look the camshafts in place using the horseshoe tool

having some dramas with the timing of the engine. all parts and tools genuine Renault and have done this timing belt 4 times before without any issues. I have currently rebuilt the track car engine, and having dramas setting the camshafts. The inlet seems to spring back, and the timing tool...