Search results

Looking awesome!

Pretty sure thats castor mate. Have you tried removing the camber bolts and just running factory alignment?

Re: JDM Y0 - My new project **** Wheel refurb and 30mm drop PG24 **** Where did you get your wheels done, I assume they are paint being Champ white? I've been trying to find a proper place that will use IXEL paint codes.

Just bought my ticket!

1. Tom 2. Scrooge 3. Toby 4. Boosh 5. Brian 6. Revels 7. Nik 8. Seb 9.Burpspeed.com 10. Addicted 11. Jon.G

1 36oz bottle of G101. Done.

Aye, I should have two, but I only ordered one with a deal that was on DW a while back.

I noticed something reading that, you put your grit gaurd in your main wash bucket. Now I've been putting mine in the rinse bucket. Is this wrong? :o

Manchester sucks.

Yes.

How weedy are them bottles? How much were they? Nice variety of brushes though!

See Here: http://www.cliosport.net/forum/showthread.php?87920-All-you-want-to-know-about-insurance-!!&p=1008415&viewfull=1#post1008415

It's still M33. 2nd worst postcode area in the UK.

LOL, Yes. Best I've got is £1200 from either Greenlight or EUI Group.

Just a heads up about Livingstones Warman, If you're under 25 they will not insure you.

TBH I'll be the same, Just get the buckets round the back of the house, fill them up and get on with it. Get a watering can out to rinse the car. No hosepipes used ;) It's not like I'm leaving the tap on pissing water everywhere for no reason. I know plenty of people that leave taps on...

WTF would you want Downforce at the rear anyway. It's a FWD car FFS.

Like Mr Billy said, I'd always have the better set on the rear, unless for some reason the car tramlines with a certain pair being on the front. IE mine.

I am slightly tempted to get some in 16's for my standard wheels. But I know how s**t they'll be in the wet!

£5.49 http://www.elitecarcare.co.uk/sonus-foam-applicator-pads-pack-of-6.php?osCsid=d3559f9c1921381ea0afe0af02319a1b Been using G101 to clean some suspension bits. Diluted it 4:1 as I wanted it to be pretty strong to move a load of s**t, f**k me its good.

Which one did you go for?

Seen as the belts will have to come off to do the cams, you may as well. Doesn't look like the aux has been done with the cambelt. Was it done at the 36k interval at all?

My order came through form elite car care today, some top ups and some new bits. Still need to order new cloths and towels as well. Got the bilt hamber hydrate 80 to treat the rust on the SACHS dampers.

Aye the Ph1 bootlid has holes on both sides. Shitter really. Which new RS badge were you thinking of?

Lol. b*****d. Fingers crossed for this week!

Same plate used on my 1.2 and the Trophy. Both fit very snug and nice. Checked my order from when I bought them the specified size is: Front : 520x95mm

I'll have to measure it again, but I think its 92mm. Its obviously still illegal, I must point that out, However its a good middle ground IMO.

-1.5 rear and 0.5 front, So I believe.

One of the dampers is fucked again, so they are back at BG getting sorted this week.

I'm out mate, Car is OTR this week.