Search results

do u still have the splitter ben_ren19.16v??????

adi wot wheels are they on there?? they look well sweet!

MIGHT SEEM LIKE A SILLY QUESTION BUT ITS ALWAYS BUGGED ME............ Why is the turning circle in a car different when reversing and going 4ward???!!! i can reverse out of my drive with FULL LOCK but if i try and drive stright back in on FULL LOCK, i have to reverse slightly to avoid hitting...

i couldnt find any information anout the LOW OIL/TEMP sensor or the OIL PRESSURE sensor anyware in the haynes manual??????

whoops! ignore that post, i was getting confused with the OIL Temperature sensor!! unless they use the same sensor???

ITS LOCATED AT THE FRONT OF THE ENGINE, NEAR THE OIL FILTER, BUT BIT HIGHER UP, QUITE AWKWARD TO GET TO THOUGH

Which one is it javascript openWin pop_up_profile.asp?profile=4729&ForumID=6 , profile , toolbar=0,location=0,status=0,menubar=0,scrollbars=0,resizable=1,width=440,height=370 ">ben_ren19.16v?? As theres a couple of types, one with holes and one without and one with half hole half without!!!!!

Can anyone still get hold of one of these??? ive triede to get one from round my way but they dont have any.

This is from a previous post by me! This is a bit long but i have to explain everything so sorry!! Was at my local tesco last nite and there were a few young lads (bout17-18) at the top of car park messing around. i came out the car park after filling up and a red m reg valver...

f**k me it must scream like a b**ch when it gets there??!!!

Both i suppose, check my other thread about my car sitting low on one side

Yeah the ones on ebay!!!

Ur cars Chipped yeah??? wots the rev limit then in each gear???

Me Again!!! are williams shocks same as the valver??

Kent high lift cams rally race spec. For a Renault clio 16v or williams or a similar type engine. Matching lifters and Blue fully adjustable pulleys. How much would these normally cost and wot sort of power gains could be achived, being in mind that my car is already chipped, IKd and...

This would explain why my car pulls to one side, i had the tracking/balancing done and it still seemed to pull to the right???

Its not lowered though as far as im aware

I always thought thata the rear of my car looked odd so i measured the bugger today and found that the drivers side rear sits about 1 Inch lower tan rear passenger side!!! My thought is a Fooked shock absorber????

hmmmmmmmmmmmmmm FLAMES!!!!!!

I want flames!!!!!! how to get them???

250 on ebay some ive seen cheaper

I have got a clifford concept 500 (i think!) on my car and its obviously wired to the central locking and boot to lock them. Now i have brought a solenoid boot release kit and am gonna get id of the lock on the boot but do u reckon il need to disconnect the alarm to the boot lock?? if so is...

Ive got 17s on my phase 1 and it Hasnt been lowered and it looks about the same as urs at the back, front?? possibly lowered

I think all the handbrake covers/buttons are squarish but when u take the cover off i assume it reveals that u can take the button off and attach a round one so you can put a round handle on there??? underneath the cover is just a bit of metal and its not the shape that the handle is (hope...

Ive got a Richbrook handle and gonna get the gaiter later once i figure out how to get the handle off!!! The back plastic cover is easy it just pulls out but its the rubber handle im having trouble with. Mind you im not entirely sure the Richbrook handle ive got is correct one, its round and so...

Wot do you mean the handle might fall out??

So wots the difference between sts and performance clutch or is there no noteable difference??

How do you remove the handbrake cover on a valver??? it says to prise it off in haynes manual but it wont come off for sh*t!!

i never said a standard one was under-performing, thats why i asked if a K-tec , bb or woteva clutch is worth it???

My clutch is on the way out and was wondering if its worth getting a performance one?? Both BB and K-tec do them but are they worth it???