Search results

Its Carl.

Was nice this before the meg engine went in it

I literally just sold a set of 60mm hubs 😂

Fixed that for you.

Hows it look from the other side of the hub? They stick out a bit dont they? @Touring_Rob did his recently

Surely if the front hub nut has been torqued up to spec it should be sat in the correct position? I'm still going with the hub being bent

It's easy to check if bent but some shops often use the carrier bolts to support the hub during pressing.

More than likely theyve bent the hub. They need bracing properly as this is insanely common when garages just throw bearings in.

https://www.brtmotorsport.co.uk/collections/braided-brake-hose-kits/products/brembo-caliper-link-hoses

Had some black stickers in my kit so just shoved that on and I'm pretty happy with the result! Red rubber grease on the piston seal and pistons then dust seals pressed into place. Fitted my braided link pipe from @BRT Motorsport which looks ace. Now to do the other one 😂

Its gonna be stainless then 😂🥵

Will it include multiplayer? Or is it literally only multiplayer on 1 game mode?

Coatings on the mating faces for either the wheel to hub or nut/bolt angle.

Dont need to look behind you, only ahead.

Itll be the ones on the far right (black cables going to the pin). The corrosion will be obvious

The foglight will be the earth pins on the rear light connectors

I'll get some special brumbo stickers I'm happy with the colour, need to resist touching them too early now! Stickers are gonna go over the top of the lacquer as read issues with them causing air under the lacquer and peeling them at temp. How true that is I dont know... Silver or black are...

Thanks mate, appreciate the kind words! Started painting my brembos after all the prep. Took my time masking, using orings in the seal gaps before finishing with tape. Ear plugs were also used to block all the holes up! Only 1 done so far as I ran out of orings. Pretty happy with the finish...

They barely manage to fit a wiper

Bradford kyle also likes pulling his head off, not picking heads.

Welcome Burnley Kyle. We also have a resident Bradford Kyle @Romanian Tyre Fitter

I'm always driving in m(62)exico

This looks epic Steve!

No chance.

Is that a family heirloom? 😂😂

Thankfully amazon replace them no questions asked but it's really not good especially as I'll be approaching the year owned mark.

You can fit the heatshield once the starters in 👀

Welding up this b*****d. Currently left on my mums driveway until I have space and motivation to sort it out 😂😭

Check the wiring on the efi module