Search results

They do fit, they just rub on themselves and fail prematurely.

One rib, i used jubilee clips to replace the cv clips too. Never had an issue.

That's the one, you'll want to get a cone too for fitting. You cut off a rib on the large side, maybe even take 2 off? I can't remember.

Pull the top of the door back slightly, get it by where the seal is, simples.

JR flexi boot. Cut off one of the ribs so it doesn't rub on itself and they're grand.

Coat hanger to the unlock button on the dash?

Wrapped bundle is for the red aftermarket alarm light in the centre console. The cable is a speaker connector, does your car have satnav? On satnav models they had a speaker above the cup holder in the middle so appears to be from that. Unsure on the other cut cables. Car may have had a nee...

Think hes still active on here @Mike@Rentech. Do you remember the car? I guess a number plate would help 😂

If its slipped then itll be bent valves unfortunately. Check out the alternator belt, and again...when were the belts done and by who?

Were the belts done recently and who by? Check the alternator belt is still in place and not wrapped itself around the cambelt!

Go for 12 mins toe out. That's standard and more than sufficient with about 1.30 camber

That's looking fantastic Paul, top work! How easy are the wipers to remove? I wouldn't mind cleaning mine up similar

Probably silver

Looks great but pleeeeease move the axle stand under the car. The front sills crumple for fun

Where are those mats from mate? Look fantastic

Anyone know the OD of the bottom rad hose? Wanting a new clip/clamp that bolts to the subframe. Presume the generic ebay ones will be fine?

Carbon canister?

Pop a multimeter on it to see if battery. If not, check pull on the battery with the multimeter and remove fuses until it goes away.

You sure that hasn't had a spraycan respray?

That is looking sexual. Colour match is spot on too.

Cheers mate, Didnt know what a 200 looked like

I'm not free for the next 3 weekends :eek:

Dont bother moving the battery tbh

Dont blast it with a pressure washer. You just push the dirt deeper

Earth

New clean plates and a respray of the tow bar and itll look mint

No idea why they change things that work! If that release bearing has been original to the car it's done well! Cheers mate. Exactly that, everything but the kitchen sink changed now! Fingers crossed it drives well this weekend once back on the ground. I had a quick nosey at him and he seems...

It isn't bad for the mileage! Getting to a point where it needs bodywork, but its just finding someone reputable that is difficult. Cheers mate. Biggest job i've done on it since the beginning of ownership!

Tapped in the little centering ring, fitted the new clutch and torqued it all up, pain free. New gearbox had the release bearing fitted with some lube on the shaft and this was slid straight onto the block with absolutely no issues. Literally took 5 minutes to mate it to the block when we were...

In the mean-time I stockpiled new parts ready for fitment when fitting the new gearbox. Parts were a genuine Valeo clutch, Febi lower engine mount to replace the one under the gearbox as it had clearly never been touched, MTL oil as recommended by @JamesBryan and Mark, new earth strap as the old...