Search results

The brembo and ds2500 is tried and tested and the most popular combo, just bite the bullet and pay up. Or you can always go standard nout wrong with it

Re: Mk1 172 Hybrid Track Car Project How did the car fair against others?

Pretty hefty price tag too for the calipers i expect?

Im pre ordered status now

Looked an amazinhg weekend of racing and camier was on it. So much detail in the shots i love it, #9 do you have this in full res without the watermark, looks a stunner for a desktop pic, pm if needs... I no I no, it is cheeky lol

Nice wheels :D

pressures ok? suspension ok? Oil on the corner? wet? Youl want to scrub them in to

Yup all sorted, it was weird. If you pump the pedal with the engine off it would spin slightly, but with the engine on it made it worse, almost to the point you couldnt turn it with your hand.

I like the red and blue samcos tbh, looks different but no silly imo

In that case take the bulbs out :D

Ish... lol I know that I have those lights on and the reason is that my SAS is not working. I beleive if hes putting the 172 clocks in and its got the 172 lump/ecu then it will throw up these lights?

Have you got the 172 steering angle sensor in and wired?

Cheers for the reply pete In the end I gave Fred a ring, I didnt grind enough off each pad so did that, but then sometimes it would get stiffer. I copper slipped everywhere and still no joy. I then turned my attention to the sliders, in a combination of cleaning then re-greasing etc They...

Re: Mk1 172 Hybrid Track Car Project Rig up springs to mind

The alarm sensors are on small clips, it should just pull out of the holder

just put the wheel back on, spun it and it was free. Pumped the pedal and now its alot stiffer asif its stuck on

did about 30 presses of the pedal for 4 seconds at about 60mph and 50% pressure as ferodo recomends

as with anything, can only tell what itl be like towards the final stages of completion. Could look amazing, or could look like a trajedy

Fitted the DS's with brembo HC's yesterday, Had to grind down 1 pad to fit, Shims ARE removed. Copper slipped the rear of the pads and about to regrease the sliders now. Im sure though that they are binding, I cant hear any noise but just as you roll to a stop you get the sudden stop as...

try youtube for vids and just watch how they do it

Can you get a junior hack saw on it and cut a slot in it? If so apply some heat and use a large flat head

I use harnesses on mine, they shouldnt come with a harness slot otherwise

Sounds a plan, just remember to work from the edge. Any air bubble can be popped with a pin

Nope :) Just stick it on, if its a rally replica it wont matter if its rough, have you seen most rally cars up close...

Il do it for a 5er

That manifold is a work of art

I think they studied my driving on our nights and realised I need an uber slow car

Sounds like a race in these could take all night lmao

when are you going back live anway?

Ceramic coating....