Search results

heres mine mate, i got my light removed via the clip tool from mike at rentech a good few months ago, hasnt come on since!

dam! pm sent!

u got a wiring diagram matey? where do these new sensors fit??

hi guys, does anyone have a wiring diagram avaliable for a ph1 172?? i spoke to omex today and they said i require the following sensors: tps coolant crank air flow sensor (i think) where would these sensors be added too??? should i go for a preassembled or fully assembled loom?im...

right had a look as to where i can get one from, isit possible to fit this myself and use a basemap just to drive it to a local mapper??

which DTA model is that mate?

cheers dude ill check that out!

i can just about afford an omex but i want to see if there are other methods that can be used and just as good

can you do it mate?

for someone with not alot of knowledge about mapping im guessing its going to take quite some time just to get wired up?

aparantly it is pretty basic but i have no clue as to what parts i need to get it to work! been on the website and it does look prettty good!

which one would you recommend on a budget that would do the job mate?im thinking megasquirt but have no idea how to install it?

hi guys is there any alternatives to mapping tb's other than omex? thanks!

lol yeh that was me!!i live near clayhall park, was visiting my unc's house!

it may have been me mate, but i have superleggras not turinis, where did u c it?

hi guys i currently have a ktr exhuast system fitted with a janspeed decat which sounds the nuts, but i will be fitting tb's in the next few weeks and im sure the ktr is 2.25'' whereas many people recommend a 2.5'' system? wouldnt this be too loud with only one back box and decat? what...

hi guys wheres the cheapest place to get an omex inc loom from??

thanks guys!

i see, so if i used an omex then i will have to get one when its being set up?

is a wideband needed for a tb conversion?i have 2 lambdas on my 172 so dunno how to go abouts it?

im gonna try doing that, but isit ok if all the grit gets up there? im waiting on 2modified to send me the rear platforms for my fk's as im running normal lowering springs at the moment on the rear

hi guys on my ph1 172 ive got 17'' superleg's and they foul the rear somewhere even without anyone in the back - all i have in the boot is a small sub. its only decked on the back 40-50mm aswel. any ideas?

adv's same as above dis advs same as above but mine scrubs overall, value for money!

whats the engine spec of that dude!!i want flames!

they are fk coilovers mate

this is what your ph1 will look like on coils hehe

can the v6 discs and calipers both be made to work in conjuction with one another on the 172, im guessing a bracket will need to be made?? im after discs that at at least 300mm so they dont look small behind my 17'' superleggra's, i dont mind swaying away from the wp pro stuff if needs be!

my car had them when i bought it, it was running standard pads at the time, then i changed for greenstuff and it was much much better however, im getting a vibration through the brake pedal and i can see that the brake discs are wearing very unevenly on the surface so that may be the cause

are these calipers 4 pots???would they fit a ph1 172? current i have the wp pro 310mm brakes with bracket for standard caliper, discs need doing soon so am considering the calipers also cheers

after speaking to yoz i think ill give the single tb route a miss for now and concentrate on getting headwork, cams and remap done for time being!