Search results

Ahhhh he doesnt work there. you all i can say is they give you lots of discount 4 shockers at £30 are £120 think they have got it wrong.

Yes it was my 172, yours gets alot more abuse when i comes in our workshop :rasp: Easy to change but you are a student.

lol and next time you go to cooks and spot me in the car park post a spotted thread. hehe

on my log book it doesnt even say mines a sport it says its a clio RL cant remeber what happen when i insured it i dont think mine was recongised had to type it manualy

check the other thread

I would show them photos and look and find some on the internet for sale with similar age and mileage.

Temp sensor connections, theres always been a problem with these either tighten the pins or new sensor as well its located just behind the air box to the left in the thermostat housing if you take the elbow off you might see it easyier

The gearbox doesnt fit end of. i think the engine did but the chassis is in the way of the gearbox.

You mean i wont see it again? im going yey inside hehe! sorry to see it go mate

Gold service front spring some bulbs and front fog light. car was very dirty.

Your cars been there a number of days. Left today

depends on you. it may not work just sealing around the edge, if you get a pin hole game over. plus it may not bond properly

seems very cheap, cat D write off? they should be £4.800-to £5k. i have seen an 03 plate and a 52 plate up for £6,999. near me. or is that the cliosport mark up price?

dont use a lot of sealer on the frame is my top tip

when we do the whole modification to the frame the manual ones take 1 hour start to finish

the look at the head lining inside there is a seal so it looks neat inside that just pulls off. then there is a ring of 10mm bolts around the frame

^as above plus is the clutch stiff?

if its coming in by the sun visor. it will be the frame to bodywork seal. the frame needs taking out and sealing

upper right of the fan unit. on the heater box

they have to be 1mm or less. if i remember correctly

Edde has told you. the resistor pack has failed it WILL be this

Master cylinder/clutch pedal

No exchange availible. New unit is £350. nothing else will work

Who said about metal? it was water damage it can bend a valve due to them being closed at time of compression it bends the rod cos it cant compress the water. thus no compression cos the piston wont move up properly due to it being bent. If that makes sense

i brought a bearing for my rear from renault although im staff cost me £20 and 20 mins of my time

City motors. Normally are pretty good i work for the other dealer S J Cook. both are the same company but we are normally good.

no from 1998 onward springs all round

interor temp sensor is up by the interior light there are different types on 182. look for a little blue dot up by the light these are the better type ones. is the heater on auto? mixing flap motor is behind the dash, so its dash out just to get to it. there were some threads about this before.

yea have you taken the magnex extra braket out?

what dealer in bristol? Put it on the ramp take a photo?