Search results

Or even your engine oil.

Can you not see how the old one is fitted? There are just 2 large black screws at the top fixing into the slam panel, 2 push fit clips above the diamond and the bottom off the grill just has plastic clips holding it to the top of the bumper. Undo the 2 top screws and gently push the...

Euro Car Parts sell complete headlights that look and fit the same as OE's and a lot cheaper also with black or grey inserts. Not sure if they do Xenon versions.

You can measure it yourself within a couple of mm's

Perfect.

They are bigger than that I'm sure M14? on a 172 Cup. You looking at the right bolts? The ones at the bottom of the strut under the spring pan and theres 2 off them.

50kg. lunch????? Did you eat the wife?

How about Dark Silver? Also reminds me of Fords Gunmetal Grey in the 80's

The ET value is sometimes stamped on the rear of the Hub, you'll havw to take 1 wheel of to check, then buy another to match.

Wheelnuts tight?

Pads worn? or cable stretched too far would be my guess.

Give the thread a spraying of easing oil and with the van standing on the ground use the impact gun.

Taking the CC out should not make any difference, well, at least mine didn't.

I'm the only Clio on the Skoda only session, look out for me.

It's only a trot down the M6, M5, M4.

If the car is off the road whilst you are doing other things then Save weight and cut & plug the pipe close to the plenum/top part of inlet manifold & cut the pipe back towards the tank. Thats the best way. And why aren't you at the Briskoda meet at Castle Coombe in April? I'm there but...

The layout in Part 14 is exactly what you have on your car. If you follow the 2 black pipes from the Carbon Canister, you will see one go to the left hand side of the Plenum chamber (Which is the top part of the inlet manifold. The other goes under the car floorpan to the fuel tank. You can...

Mine cost £7+ as well. Definitely not £40.

Are you sure he said it was the Cam Cover gasket and not the head gasket?

Easiest thing to do is cut the 2 pipes cleanly and join them together, the valve in the top of the cannister just pulls off, leave the 2 wires connected to valve and zip tie them to something solid, if you leave the wires undone you'll get the emmision light on.

Check on the Eibach site if you have the right ones.

Wheel nuts? Are you tourquing the bolts up properly? are they OE? This shouldn't happen on a car at all. The only time any of mine come loose is when on a trackday due to the bolts heating and cooling.

Why go from a 1*2 to a 197? The 200 cup is supposed to be even better.

So does that mean, Former Owner, you want to buy another Clio?

For a track car a PH1 172 or Ph2 172 or Cup will be good for a trackday motor, find one without aircon, healthy engine, gearbox and fix the other bits yourself. Plenty available.

Thats a good price, I'll see if they are still available.

The reason why many Cliosport members use Eibach springs is because they ARE good. When you take off the old oe ones you will see how cheaply made they are. I guess you have already noticed how hard and crashy the oe sprins are, new ones will be worse. Try the Eibach Prolines, they are good...

I doubt if just looking under the car you will notice if anything is subtley bent.

You might just as well overhaul the whole braking system while your at it, new fluid pads & discs. Change the fluid as Clouder describes. It will be a day well spent.

See you yesterday a couple of times, last time in Jet tyres after 5pm.