Search results

no it says Apex at the top, they're s**t, Eibachs ONLY on the sports

LOADS are damaged repaired also

indercater

Pros - awesome cons - if you can't drive you will crash (fact)

^made in the same factory as KW (KW owned brand) it's KW's "budget" brand, but the quality is good, PLUS if they leak or whatever you can have them rebuilt by KW UK, same goes for Weitec (KW owned also)

who gives a f**k about diesels!

400/450 rears off the top of my head, i'll stick my head under the car tomorrow

NO W30 allowed in renault engines!!!

oh well, you were close to perfection! 1 more day and you woud've had it

oh i dislike the k-tec/raceland/vmaxx whatever it is just as much as GAZ, if you want suspension, BUY GERMAN, Witec/AP/KW, H&R, Bilstein etc, none of this "i only have £500 to spend" SAVE UP SOME MORE!

push the poly ones in by hand then rotate through 90degrees

superS - too expensive OMP - do they do one for the 182? orbisoud - expensive and a bad fit

being 100% honest i wouldn't touch GAZ, always go german

GAZ aren't the best for the clios, ok, but i'd put them in the mid range

going into the first week of september fella at the moment

sports, done

nope, you're looking in the wrong place ;) passenger side above the axle is where they fit

^you sure?? you're on the list for one of the 4 i have available?

^not quite for FULL cup suspension you need new the following cup rear stub axles cup springs all round cup dampers all round different wheels cup hubs cup driveshafts i thinks thats it

he probably wanted to give you some man love, Ali is a bit like that you see ;)

they're only about £4 go buy one!

why would you remove the battery terminals and the throttle body AND the coil pack, long winded approach!

this thread cause IE to crash 3 times!

tensioner is jammed then, new kit for you

^correct

i'm to busy to answer e-mails, just call me

i can supply any lines for any car toby

why didn't they spot the broken alternator pulley when the car was apart, i do these day in day out, you'd notice that even if you were blind, i'm betting money they've damaged the pulley putting the aux belt on, i see it all the time when garages who don't have the tools/experience work on...

not a good idea, that's the best way to knacker a bearing

i'm taling as a garage here, i'd be 1hour minimum charge to do one