Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Like this
http://www.ebay.co.uk/itm/120-HD-720P-MINI-DVR-ACT20-Waterproof-Bullet-Helmet-Camera-Motorcycle-Bike-Cam-/300744561228?pt=LH_DefaultDomain_3&hash=item4605c5d24c
Had a CD on in the car before, sounded fine. Chucked it in the PC and ripped it to the hard drive, sounded all stattic, like it was a radio out of tune a bit. Can still hear the tune, but its really bad.
Cipied to the phone, done the same with that too.
Youtube sounds fine though.
Time for a...
Well, just fired it up. Started first time no probs. Drove to shop (less than 3mins), came out..... Stalling again.
Got home and it was holding idle about 500rpm. When revved, the engine sounded a little rough, bit tappy. I have turned it off, will whip the inlet off tomoz and check plugs...
Nice on Dan, will give that a go this week.
I started it up yesteday to move it, and it was doing the same thing from cold. Wouldnt idle, kept stalling. So I kept it revving at 1500 with my foot and after a minute it cleared and idles fine.
This has been getting progressively worse over the last two week.
Runs fine, revs fine, but then idles really shitty and low and has started stalling.
I am thinking ISCV or lambda? Throttle has bee cleaned out already so I can rule that out. No EML on the dash.
Can the ISCV be cleaned...
But i measured the buffers against the old ones and they matched. The actual C-cup part of the mount that they sit in is wider. Will whip it off again and get some heat/vice on it
OK, so mine was ripped from the rubber, meaning it needed changing.
Rather than go solid, I grabbed a second hand one for now. But on fitting, there seemed to be more movement, more space for the mount to move in. Like the rubber buffer blocks were too small. But on checking, they were the...
TYhey are more efficient at mooching about town, as they offer better cooling properties for short bursts with low air to surface movements. But once you get up into "BIG DAWG" power, and on long runs/high speed blasts, a decent FMIC is much more efficient.
Just a shame they look ugly as f**k...
PMSL.
I want the service book so I can get it stanped to date, then start adding my own services in and do as you say above, make an invoice for what I did and when, and put it in. Just want to be quite comprehensive with it.
Also noted that ebay is s**t for genuine service books for the Mk2...