Search results

Anyone any ideas what they cost new ?

Cheers to whoever set up the poll :) What you gonna offer mate ?

I was gonna start a poll but don't know how to :( Should I leave these window deflectors on ? Or remove ? Opinions welcome...

I got given this print out if it helps Is the pedal assembly circled (number 2) the pedal assembly i need to order ? As they didn't know which is worrying even when I gave him all the numbers written on my throttle pedal housing.

Following on from this thread. http://www.cliosport.net/forum/showthread.php?t=511524 I went to my local dealer. Why are Renault parts departments in Aberdeen so useless ?? I called them this morning to see if they could give me a price for a ph2 172 throttle pedal and see if they had one in...

Ah righty, don't suppose you know the size of the lambda do you ?

Ok cheers guys. Now time to find a bolt to plug the hole. Anyone ideas on thread size ?

Sounds a minter.... And the guy sounds a complete tube. Scrappy is best place for it.

Lol

Pics possible ??

Ok cheers mate. A phone call to Renault tomorrow may be in order and see what pedal is cheaper.

Following on from this thread, it was brought up that my throttle pedal may be at fault. http://www.cliosport.net/forum/showthread.php?t=511415 Are the throttle pedals on Ph2 Clios generic or do some have Fly by Wire throttles and other cable operated throttles ? By that i mean are all fly by...

Tell me about it, there are a few local garages which take over from the AA after a certain time up in Aberdeen. Needless to say i never knew that or wouldn't have called them and wasted a call out. I will post up another thread regarding the throttle pedal and find out. £40 quid aint to bad...

How do they fit mate ? I bought some a while back the same as yours but they slot in and don't fill me with confidence fit wise so i removed them. Did i fit them wrong you think ?

I'm sure i read it somewhere.....

Am i correct in saying that if i run my decat with no 2nd(back) lambda sensor and have the lambda sensor hole plugged the only problem this will cause is switching the engine light on the dash till one is refitted ? Then the light will go off, or do i need a fault code reader to turn it off ...

What a dipstick....

I called the AA out when my 172 started misfiring a few weeks ago to try and establish if it was plugs or coil pack using there fault code reader and needless to say a local garage that are sub-contracted to the AA came out with just a flat bed recovery truck and no tools to recover me to a...

Better than stone chips i guess

They probably don't know the Cup has a thinner windscreen. And if they do i'd be suprised if you do get one as it'll come down to cost no doubt. Its a bonus if you do get a genuine one though.

Lol Where did you get this box from ?

Is this gearbox issues since the ITB's were fitted ? Can't handle the power ?

It had a new tb under warranty a few years ago mate and it was cleaned out a few weeks ago when i had plenum off to change the plugs. Will look into the throttle pedal though, although i aint stalling when pushing in clutch. Limp Home mode just happens at random

My box is the same, i guess it has one of those sensors due to being a 2002 Ph2 ?

Heaters are fine now :S

Ok cheers Ali, i'll keep searching

Did you find a definitive answer mate ?

Try Demon Tweeks, Merlin Motorsport or even Ebay.

I have checked for fault codes by holding in the computer button on the end of the wiper stalk till it starts beeping and the needles start dancing. I pressed the button a few times after that and i have no faults registered. Just shows ---- (four lines) and no letters confirming a fault...

+1