Search results

Doing the wishbones is the easy part. The geo however afterwards is not!! I'd send it out and I have access to oxy acetylene and fancy pants alignment gear! Lol! Looks a nice car though mate.

Your better off going to a steel crank. What part broke? No they're the same.

Direct swap mate

You need to match the entire rotating assembly mate, not just the crank. Pistons and rods play a big part in how the engine balances out.

Lol! Yeah!

Yeah your mum always complains. Must try harder. Lol

Yeah I hit 'post' before I wanted to! Lol

I might just make a hoist frame in steel and put a block and tackle on it. No hydraulic ram to leak and s**t itself!

Yes mate.

It passed the time away I suppose! Lol

f**king piece of s**t!

All I've got to do is locate an engine crane that doesn't f**king leak!! Then it's all coming out.

Are you dropping the lot down dan? As in engine, box, subframe etc

Added the truth in for you! Lol

I give it 6-8 months. Any advances? :grinning:

I've edited this darling.x lol!

Agreed. Oh and @Cub., one word.......bearings!!

Yeah that's all I did mate.

Here: http://www.a2stainless.co.uk/Pipe-Blanking-Plugs_B2291G.aspx

You'd get away with leaving the ones near the column open tbh. I used some cap head blanking plugs in mine. I'll try and find them and post a link.

Yeah 197 has a different pump so you have to use the 1*2 cambelt as you convert the 197 head to this setup. It sounds far more complicated than it actually is. We are literally talking drilling and tapping the head to accept a bolt for an idler tensioner.

My 53 plate cup had RS stamped inlets but the 03 one I've got now are just the standard ones.

Yes mate.

Remember your hub kit will push your track width out another 5mm per wheel, so 10mm overall mate. Yeah I'm good thanks mate - it's alright I'm used to your empty promises now! Lol! You?

Just a shame that you need spacers to fit these otherwise I'd have been interested in getting a set!!

Lol no mate - mores the pity! I did manage to convince the apprentice that they have a kerfuffle valve though - it's like a dump valve, but different!! Flol!

sounds like something off Star Wars! :up:

Great lap mate!

I'd expect the idle speed to be somewhere in the region of 1200rpm for maxi and maxi evo cams tbh. It's usually the only way you'll get an engine with knobbly cams to tickover. I'll have a price on the rods sometime this coming week mate.

Just fit a ph1 gearbox. Far easier and it gives you more top end over the gearbox you currently have.