Search results

What's it worth second hand? About year and a half old 7500 miles use. Thanks in advance.

Hello Well i have a clio 172 cup. i get a slight misfire below 2000rpm. BUT.... this only happens after i have been for a run in the car. ie i can start it up from cold , the car is rough when cold and pops and bangs on over run but no misfire. it will heat up to the running temp and no...

Well it was that time of year again MOT time! i was quite worried about the rear brakes and the emmisions as i have a yozza supersport didnt know if this would effect the emmisions or not. Any way , PASS! no advisories and tester commented " cleanest clio he has tested in a while " he said...

Hello i have changed all four discs and all four sets of pads. now i went to replace the fluid starting at the reat of the car passenger side. rear of the car in the air, opened the bleed nipple and the pedal was solid and no fluid came out the nipple:S never had this happen before. can...

ok so i have a squeek coming from the passenger side engine bay area i think. it squeeks if you blip the throttle (in gear) or go over bumpy roads while accelerating or partial throttle , but no squeeking over speed bumps :S. to me i think it only squeeks when the engine moves back and forward...

Blue cliosport stickers on windows. I was siting in the mg zs 180 right next to you. Hello

Ok so i took the morning off work to remove the pas pipe the big one from the rack to the pas pump. removed it checked it , its fine. so i look again and its the pipe above that runs from the rack to the reservoir. the alloy pipe close to the rack has been hitting off of the exhaust heat plate...

i need pictures of the pas pipe set up so i can identify which one is leaking. the leaking one is at the rear of the engine. you can see it from under the car without removing the under cover. it weaping where the metel meets the rubber at a joint. The car is a 172 cup and i need a replacement...

Will a 2001 172 pas pipes fit directly onto an 03 172 cup? any differences or are they identical? i believe earlier models had smaller diameter pipes? :S Any help appreciated Chris.

As above been offered by a friend at renault a staff discount on rear disc with bearings and abs rings for £60. will they fit or will i encounter problems? can the ring be easly removed or just leave it on? Any help appreciated.

:rasp: power = 175 torque= 150 modifications :- itg panel filter yozza supersport (cat still on) Quaife lsd. mechanic says it must have matched inlets and have been previously been mapped. as far is i know its standard. how can i find out?

hello in my 172 cup the interior fan only works on level 4 . 1,2 and 3 i do not get nothing. could it be the switch? i searched and read about the resistor but i dont think this is the problem or maybe im wrong. any help appreciated.

it was saturday the 14th nov. see video @ 3min 20. was fairley shifting. any one know who it is? http://www.youtube.com/watch?v=TNVaXw7Zs7c

can any one help? i think it may be my battery. as i start my car the clocks reset ie trip millage mpg etc . its only been the last couple of mornings. the car starts no problem though :rolleyes:

http://www.demon-tweeks.co.uk/products/ProductDetail.asp?cls=MSPORT&pcode=KUM1756013V70H if so what compound? results?

and how he done it!! lol if its not rubbin its not dubbin

does anyone know if the omp subframes would make them sit lower? they currently sit on sparco ones plus opm sliders. if not who wants to SWAP>???

ok i have omp seats , sliders and sub frames. iv put the sliders on the seats i will buy new bolts to put the seats and sliders onto the subframes so my question is do i need to buy new bolts for bolting subframe to the floor or can i use the originals from my standard frames? thanks:dapprove:

here is my new cup had it for two months now, since then iv added a yozzasport zorst, itg panel filter, lsd and omp seats which need fitted this weekend. the car was in need of some dodo juice detailing. comments welcome.

ok this arrived at my door on monday last week , i had today off work and got stuck right in. many grazed knuckles later its in and i must say possibly the best modification iv ever fitted to a car did not expect such a big difference especialy when enthusiasticly exiting a corner note the roads...

is this a repost? http://www.youtube.com/watch?v=sNvWtlESSC0 spoted it a while back before i was a clio owner.

two options. 1.) http://www.demon-tweeks.co.uk/products/ProductDetail.asp?cls=ROAD&pcode=OMPHA736E 2) http://www.demon-tweeks.co.uk/products/ProductDetail.asp?cls=ROAD&pcode=S/S00961BLKB option one looks nice. any others im missing? got 600 to spend on two seats any help apreciated. thanks

hello , how long a delivery time will i have to wait on a yozzasport exhaust paid on thursday , i live in central scotland. i went for the supersport, does any one have any vids of this or pics thanks, the cars a 172 cup by the way. just want to check noise levels with a cat etc. Thanks.

http://cgi.ebay.co.uk/RENAULT-CLIO-2-0-RS-02-ON-Air-Duct-Intake-Induction-Kit_W0QQitemZ250453313196QQcmdZViewItemQQptZUK_CarsParts_Vehicles_CarParts_SM?hash=item3a502e46ac&_trksid=p3286.c0.m14&_trkparms=65%3A12%7C66%3A2%7C39%3A1%7C72%3A1683%7C240%3A1318%7C301%3A0%7C293%3A1%7C294%3A50 is this...

had a call from renault saying that my power steering switch is leaking. switch ? what and where is this? is this easy to fit a new one ? only they wanted to charge me an extra £70 for it, thanks

now thats a cheap price this includes labour and parts they have a deal on at arnold clark :):rasp:

hello, im just new to the french world of cars , iv just purchased a 172 cup 36k 03 plate just had cam belt kit done and aux belt . i am going to try and source some second hand recaro trendlines but i am strugling, could any of you point me in the right direction? id like to add the 172 is a...

should i trust an independant garage to do this? (not renault) been quoted £240 labour + parts does the engine mount need to be removed? i usualy do everything myself to my other cars but this space looks tight. what needs to be removed to access the cam belt thanks.