Search results

I read the guide on turning this off, very helpful! My question is: Does adding the resistor turn the light off itself, or must the light be reset?

I've searched and found a few threads that were helpful but its still hard to know as the set-up is specific to each car :S I have a ph2 172 cup, currently lowered on eibachs at the rear(30mmish) and 50mm at the front.Tyres are 205/45. No scrubbing or anything of that nature. However I recently...

Recently there has been a squeaky/squealy noise from the back right of the car. It happens when I steer to the left, brake and go over bumps. Most of the time I can hear it but sometimes there is no noise too. The rear callipers were new 2 months ago and the pads and discs are in good condition...

I had the belts done recently, noticed yesterday that it looked like the belt wasnt sitting right on the crankshaft pulley(if thats correct). Please advise, Aaron.

My clio 172 cup recently (couple months ago) had the brakes bled and new rear calipers fitted to pass MOT. Can anyone tell me if the brake fluid is changed when bleeding the brakes? If not I think I will change the fluid, am I right in saying 1000ml is enough? Thanks,Aaron

Just had the timing belt changed earlier today, but the fella doing the job didnt put in the new crankshaft bolt(i think thats what its called anyway) I had bought from Renault and gave to him along with the kit. He said he just tightened up the the one that was already in it. I know its good...

My Ph2 172 has a stainless system to the manifold with a ktec decat. Over the past few months though it has started getting a bit louder and sounding slightly like a tractor (hard to describe) but a few different people have told me they think the problem lys with the manifold, either its...

After looking through receipts I realise a previous owner installed KONI dampers and shocks worth over £500... :) The car is lowered 30mm on Eibachs but I have just ordered 50mm springs for the front, will these fit in on the current suspension setup okay?I don't know much about suspensions to...

Im fairly new to the forum, became a member last week but signed up about a month ago. Heres some pictures, comments and criticism welcome! Major Modifications: Full Stainless Exhuast system to Manifold, with Ktec Decat and Remus Backbox. Lowered 30mm, upgraded shocks. Brembo Calibers. Grooved...