Search results

Few various different pictures. Bodykit and Exhaust done. 15mm spacers on the rear and 20mm on the front

Civic Type-R Aerial to be fitted

I was wondering if anyone could help in solving the problem I have with my driver side seat cover. On the passenger seat around the bottom of the seat cover is a fastener string that's tensioned to keep the seat cover tight over the foam and on the bolsters. The driver side doesn't seem to...

Thanks. It sits much better on the flat but I understand what your saying :)

Turinis on and after a good clean

Got the Turnins blasted

182's put to one side to refurb these Turinis

They connect to Crankshaft Sensor

Is it this your having the problem with??

Headliner is in. Weather was good so made the most of it.

Headliner finished in Alcantara. Hopefully get it back in the car end of next week depending on the weather.

Got a mate with a Toyota Glanza with them on and it looks sweet :)

No worries. Let us know how you get on :)

Sadly I didn't take any pictures when I was doing it as it was starting to rain at the time and wanted it on :) It was relatively easy, the hardest thing was undoing the 10mm bolts. Like you said the 10mm ratchet spanner made the job much easier. I could take some pictures when I'm home from...

I also took the metal frame off the car and re sealed down with automotive black sealer. Have to take the glass out of the sunroof, then remove the sunroof trim surround that holds the headliner up, undo all the 10mm bolts that holds the frame down. The factory seal they use is also terrible...

Is rare they need replacing. When I came to do mine the drums were on solid.

Oh right fair enough, they should do. Went by the reasoning the bearings were being changed in the existing drums.

If you have the ability, get some compressed air down the 2 sunroof drainage holes. Get someone else to listen to the corners of the scuttle panels where the water drains to, to ensure the pipe are free.

I had the same problem and only found the source of the problem recently, but could be different problem your experiencing. There are 3 drainage holes located in the bulkhead found under the scuttle panel at the bottom of the windscreen. There is one drainage hole at each side of the car and...

You will need garage to press old bearings out and the new bearings in.

Agree :) Get the original Grill in and some 182's or Turinis and will look smart

I've seen that one around the Sowton area of Exeter. Very Clean V6

Bet it gets alot of attention :) What set of wheels are you looking to get?

Not sure whether they come standard but never seen one with them before. How are they mounted to the arch? If you take them off will it leave holes?

I refurbed my Anthracite 182's myself. The colour is close to the original. Majors scuffs I filled with Chemical Metal then sanded down flat, then etch primered any bare metal, primered fully with normal primer, wet sanded primer flat then painted with Anthracite paint then lacquered. BEFORE...

Looking good mate. Lovely unique colour. You painting your original wheels ice white??

Looks real clean and smart :) Did you buy it with the Mudflaps on it?

No problem :) Get the rest of the 182's refurbed and on the car then sort out the spraying of the body panels. Then all the detailing from there.

The colour match isn't too bad to be honest but as it's going on the roof and not close to the door cards or the seats then a slight variation won't really look out of place. Best thing would be to order a sample piece as that way you aren't taking my word that it's ok and each persons...

Cheers mate. I ordered the 10cm x 10cm sample first to make sure it was the right colour and texture then ordered the 250cm x 145cm. The extra length should give the ability to match contours of the headliner and ensure plenty to fold over the edges and secure it in place.