2.0 badges

[Christophe]

I want my badges refurbed like the pic and wondered how it done. do they pop off?

 

[FlameR]

yep. celotape over a screw driver head (to prevent scratching paint), pry it off far enough to get your fingers under it and pull them off.

 

[Christophe]

and to put them back on? Just pop on ye?

 

[FlameR]

aye lad

 

[Christophe]

now how do you paint the number with out going onto the black. can that seperate ?

 

[paul]

i would be careful everyone says they just pull of dead easy! i did what you should do last weekend but ended up snapping the middle clip and to this day i dont know why :S had to glue the thing back on shame as only took it off for cleaning

 

[paul]

now how do you paint the number with out going onto the black. can that seperate ?

small brush

 

[FlameR]

if the worst comes to the worst and you snap the clip mate I have a set of badges you could buy.

 

[paul]

i dont mean snapping the clip on the badge i mean the clip on the door

 

[Christophe]

if the worst comes to the worst and you snap the clip mate I have a set of badges you could buy.

How much?

 

[182laney]

Does anyone know where/if can get my 2.0 badges painted the same as the pic above? They look sweet, but i know i would mess mine up if i tried to do it myself! lol

 

[kully]

Does anyone know where/if can get my 2.0 badges painted the same as the pic above? They look sweet, but i know i would mess mine up if i tried to do it myself! lol

pm middo , he does a very very good job .

 

[182laney]

Cheers, ill pm him now.

 

[edde]

The best way to get the badged off is to take the whole bump strip off.

There a little hole under neither the rear of the bump strip stick a screwdriver up themre and pull the tap in there backwards as such and the whole badge and strip slides out backwards.

 

[HartZ]

There was a thread made a couple of days ago on this.. Have a search around buddy, Middo is the man for the job.. he has such a talent at doing these..