Advice Needed

[madhops87]

Im looking at getting an ITG air filter, Samco induction pipe for my 182. As I understand it these are a straight swap for the standard parts?
The other thing was if I have a group N remap from ktec will I be able to remove it/ change it for a different remap in the future?
Not done any engine stuff before, am I starting in the right place? Im getting a Miltek exhaust as well.
Thanks.

 

[bmh.01]

Yes the ITG panel filter and the samco bend are standard swap bits yes. As for the remap I imagine you'd have to refit the standard ecu then get it remaped I would've thought. Although it may be possible to get the grp N one done then you've got a straight swap back for the standard ecu/map.