Airbag and Serv Light

[PaulC182]

Hi, I clipped the curb the other day and the engine cut off for a round a minute, it's back to normal now, no airbags came out, but now I have a serv and airbag light on, I have already soldered the pretentioner wires before the accident and have checked them again, I have used the search function and have found no luck, what shall I do? I have an rs tuner and the car is a Clio cup 182 2004, thanks

 

[MicKPM]

So what is the RS Tuner telling you the cause of the lights is? Check your seat belt anchors to especially the height of them cos I bet one is lower than the other.

 

[Darren61]

Have you checked the brake light connection in the footwell just above the brake pedal? Make sure it's seated right etc.

 

[PaulC182]

Sorry dont know what happened there..

Here is the screenshot

Rear 02 heater fault DF0038, DF0083, DF0602
Rear 02 heater fault on activiation DF0038
Brake information fault DF0135


Then 3 air bags faults that need to be unclocked via a module

 

[PaulC182]

Have you checked the brake light connection in the footwell just above the brake pedal? Make sure it's seated right etc.

I have looked its seated right, thanks

 

[PaulC182]

Can anyone help?

 

[len_beach]

Buy the airbag module for about £20 and reset the ecu?

 

[LiamR172]

Buy the airbag module for about £20 and reset the ecu?

Does the RSTuner have to be unlocked to use the airbag module on a car?

I.e if the tuner is locked to your car, could i use it to turn off mt airbag light?

 

[LiamR172]

Nevermind.. just found this on fastchip.nl

This module can be used on as many cars and as often as you like, there are*no*vehicle licenses required!

 

[PaulC182]

Sorry to bump this thread but I have still not fixed the issue please can anyone help? Thank you

 

[PaulC182]

Please anyone?

 

[MicKPM]

Did you not buy the RSTuner SRS module? It will tell you what is wrong otherwise you need to take it somewhere for an accurate diagnostic