Evo 6 TME, Clio 172
Hi all another rough idle thread... but this is my 2nd 172 and is alot worse than my last one.
If I start car cold it idles fine while the ecu keeps the revs above 1k, as soon as the revs drop below 1k as the car settles it idles like it's aggressively cammed, and whole car shakes, when I pull off it's very hesitant below 3-4k, if I keep it going it clears
But sometimes when coming to a stop and going in reverse it cuts out, not all the time, but the car needs some revs to stop it stalling.
I run the car on vpower or momentum so its not the fuel. It's had new plugs, filter, and lambda recently so where next? I've seen about cleaning throttle body, and replacing map sensor? Are they common fixes or just a waste of time? There are no warning lights on either.
Wanting to polybush engine mounts but it shakes enough as it is
Sent from my SM-G950F using Tapatalk
If I start car cold it idles fine while the ecu keeps the revs above 1k, as soon as the revs drop below 1k as the car settles it idles like it's aggressively cammed, and whole car shakes, when I pull off it's very hesitant below 3-4k, if I keep it going it clears
But sometimes when coming to a stop and going in reverse it cuts out, not all the time, but the car needs some revs to stop it stalling.
I run the car on vpower or momentum so its not the fuel. It's had new plugs, filter, and lambda recently so where next? I've seen about cleaning throttle body, and replacing map sensor? Are they common fixes or just a waste of time? There are no warning lights on either.
Wanting to polybush engine mounts but it shakes enough as it is
Sent from my SM-G950F using Tapatalk