Can someone help me identify and fitment of this ? Part of gear linkage ?

[finch wxm]

I'm just in the middle of finishing off my engine install

can someone guide me ?

think this is part of the gear linkage underneath ?

cherers


finch

 

[Fred@BTM]

dogbone to box bracket

 

[finch wxm]

Cheers fred , found a pic after ! Just trying to fit now .

need ramps ! Engine and box need o move to line it up

 

[finch wxm]

I can't quite work out which hole it should go into when bolted to gearbox mount

 

[Fred@BTM]

see the 2 bolts on the right of the pic on the box, 1 is missing? there's a bracket that is held on by those 2 bolts, the bar bolts to that and the the dogbone, its no really needed anyway, so don't worry about it

 

[finch wxm]

Ahh cool , I thought there must have been a bracket missing or summit as when I bolted it up it wasn't sitting rite.

will leave it off then Fred if it's not doing a lot .

what would be your advice for initial start up after it being off the road so long ?

Its had new cambelt and de phaser oil pump and clutch fitted by the guys in malpas

would you advise disconnecting the tdc sensor to Makesure I get oil pressure etc ?

 

[Fred@BTM]

plugs out (unhook injectors too) and spin it over for 60sec (in 3 20sec bursts)

 

[finch wxm]

Cool , leave the inlet off then while I do this I take it ?