cold air feed

[Tim]

i have put an induction kit on my cup and was wondering on what i should do with the small blk rubber pipe which comes off the old factory one which joins to the engine as i want to take out the factory pipes so i can run the air feed down to the front . any advice would be good .???????????

cheer's tim

 

[Tim]

anyone help

 

[Maz]

Mine has been taken out iirc as I wanted to do the same

Ask Ben and Admits Tim .. drop them a pm or give them a bell

Marie

 

[makavelli]

are you on about the small tube which leads to the acoustic valve? if yes then all i did was cut it off by the point where it meets the manifold and plugged it with a screw

 

[Cupster]

I think it is a breather pipe? I put a bit of sponge and old air filter material in the end and taped it to the side like a mini filter of sorts.

 

[makavelli]

I think it is a breather pipe? I put a bit of sponge and old air filter material in the end and taped it to the side like a mini filter of sorts.

thats wat i thought it was but thought it was to do with the acoustic valve and its operation and therefore thought, no acoustic valve, no operation lol

 

[Tim]

chee'rs guys will try this

 

[Tim]

cheer's all sorted