Exhaust cut out

[Willsam]

I'm fitting my exhaust tomorrow and need to know any simple methods of cutting out part of the rear bumper

 

[cs_dave]

Mark up up and cut mate

 

[Willsam]

Mark up up and cut mate

This is where your rear bumper would have been useful, was just a bit too late, exhaust sits just under current bumper, need a better exhaust mount when I get new bumper

 

[cs_dave]

Use where your exhaust sits now under the bumper as your location with a exhaust surround black plastic thing put it against the bumper and mark the inside cut this cut will be abit small then slowly increase the size until the surround fits lovely then once youve done the mount it will lift the exhaust in to your cut out

you hope lol

 

[llgsimpson]

either draw and cut, or let the exhaust make the hole

 

[Knuckles]

Use where your exhaust sits now under the bumper as your location with a exhaust surround black plastic thing put it against the bumper and mark the inside cut this cut will be abit small then slowly increase the size until the surround fits lovely then once youve done the mount it will lift the exhaust in to your cut out

you hope lol

I can't make heads or tails of that without at least a couple of commas.

 

[cs_dave]

Sorry for my bad grammar

 

[Knuckles]

Sorry for my bad grammar

Not a case of bad grammar tbh, I just couldn't read the post

 

[Willsam]

Sorry for my bad grammar

Seen on here somewhere someone selling 1 182 exhaust surround, if i cut out my bumper and put that around it would work wouldn't it?

 

[cs_dave]

Yes mate that's what I did

 

[PaulSA197]

Not a case of bad grammar tbh, I just couldn't read the post

You're such an idiot!!

 

[Knuckles]

You're such an idiot!!

Pardigan?

First post as well, you're going to be interesting.

 

[MrDave]

Brb getting a brew