Help please!

[Ryancarlin]

How do I remove the door plastic strips? Help someone!

 

[Dan@M.A.D]

Slide them towards the rear of the car on the door, I think the rear part slides forward.

 

[Ryancarlin]

Just tried that but they wont move, do I have to lift one end out as I push it?

 

[joej9]

Just push them towards the edge of the door. Elbow grease needed as well lol

 

[Ryancarlin]

So am I pushing them to the front or back if the car?

 

[joej9]

Back mate. I remember taking the bullets off, just to be safe, then pushed the strips against the door and pushed forward at the same time.

 

[Dan@M.A.D]

The large part on the door slides backwards but i'm sure the small rear one slides forwards.

 

[joej9]

Aye think your right there mate. I Probably should of mentioned that tbh

 

[Ryancarlin]

How do you take the bullets off? They won't budge anywhere!

 

[JamesBryan]

Once the side strip is removed, there are clips behind it which hold the bullet in place. These just need popping out.

Careful though! The clips break easily :nono:

 

[Ryancarlin]

I can't remove the side strip, is there any tool I can use?

 

[JamesBryan]

I can't remove the side strip, is there any tool I can use?

Not really no.

Just grab the bullet at the front, as this is a good finger hold to grab on to.

Then just slide the strip backwards. Open the door too, that will help

 

[Ryancarlin]

I can't get them off it's like there super glued on!

 

[JamesBryan]

Get someone to slide them from the back as you slide from the bullet at the front

 

[Ben..]

Warm water over it will loosed up all the dust and caked on shite

 

[Blacky950]

Open the door and look at the inside at the back and you will see a little rubber grommet take that out and youll see the back of the side strip clips get a flat screwdriver and try and slide the clip to the back should come out with no much force.

 

[Ryancarlin]

Open the door and look at the inside at the back and you will see a little rubber grommet take that out and youll see the back of the side strip clips get a flat screwdriver and try and slide the clip to the back should come out with no much force.

cheers mate did that and they came of easily, thanks a lot pal

 

[Blacky950]

No worries mate