How to wire up components?

[AhmedRSi]

Got a set of infinity 5010cs components

I have

- Speakers
- Tweeters
- Crossovers

How do i fit them? Thanks

I am going to cut the old speaker wires and solder on the new speakers. I understand how to fit the speakers/tweeters but what are the crossovers and how do i hook them up?! i dont even know what they do!

 

[AhmedRSi]

Bump. Thoroughly confused...

 

[wallop]

Been covered a few times recently....

The crossovers limit the frequencies being reproduced by each seperate driver, (mid or tweeter), which theoretically improves sound quality....

For wiring info SEE HERE, POST 8 , should just about answer your query....

 

[AhmedRSi]

where is the "from headunit wires" ? do i feed the new wires through the doors etc or just use the existing wires? same with the tweeters?

 

[wallop]

The 'from head unit' wires actually come from the head unit....

They split at some point behind the dash to feed the door mounted mids & dash mounted tweeters....

You can either splice into them behind the head unit or in the doors, but you need to connect your new drivers to the 'crossovers' & your 'crossovers' to the head unit as shown....