I.K.&chip! Any advice/thoughts

[felix16v]

My engine is totally standard and im thinking bout improving the breathing and maybe a chip to flatten the torque curve and increase acceleration in the lower revs!

any thoughts or recommendations?

felix

 

[steve a]

Yeah pannel filter with 70mm air feed from the airbox to the foglight/gap next to it. Decat pipe, and make sure it has a good service i.e pluggs, fuel filter, dizzy cap rotor arm, leads, oil and filter. Once thats done then maybe a cat back exhaust. Hillpower do chips for 150 which you might want to think about.

 

[felix16v]

im not taking out my foglight but there is that rubber bit next to it id take out! where would i get a panel filter from?got the decat and cat back exhaust and its getting its 72k done at bb! are the hill power chips any good?

felix

 

[Matty]

Valver I take it ????

I replaced the K&N my car came with to a BMC CDA which is much better. Had a BB chip fitted when I was down there for cambelt/water pump replacement and would recommend them.

As for IK, only BMC CDA or Viper to chose from really on the valver.

 

[felix16v]

cheers matty i was thinkin of gettin the bb chip. they are good boys over there!

felix