inlet matching

[partyboy23]

what part gets matched?is it the part with "rs" stamped on it?if so how do you remove it,i got the plenum off,then the next bit that goes between the 2,undone all the bolts i could see for the inlet stamped "rs" bout it was still well tight on the block?

 

[Toxic#66]

This should help You, just made it (not all screws are visible on the picture but arrows should point You in the right direction)


Remember one big screw from the side, and another 2 are well hidden under AC mount (touhg one to unscrew but i did it)
(take notice of that 2 cause I missed one arrow or maybe not, not so sure right now

 

[partyboy23]

yeah had all them out apart from the big one on the left hand side of that picture,how does that come out,i had dramas

 

[Toxic#66]

surprisingly easy (on a hot engine), it's hart do get it out thou, hard to get a good grip and not to let if falldown. But unscrewing patr was easiest of all. I'll post You the image of a tool I used at the morning

 

[partyboy23]

ok cool dude,cheers